Part Number: INA293-Q1 Other Parts Discussed in Thread: INA293 Hi,
We are using INA293-Q1 and want to add output low pass filter going into our ADC. I am targeting 100ohm and 10nF.
Is the output stable for this condition? How do I choose the output RC…
Part Number: INA293-Q1 Other Parts Discussed in Thread: INA240 , INA293 , DRV8323 , INA241B , INA180 , INA281
Hi
Is it possible to measure the phase currents of a three phase motor control application with the INA293-Q1? I used the INA240 before and this…
Part Number: INA293 Other Parts Discussed in Thread: INA240 , INA290 hello
I am using the INA293A2 as a current measuring device on one of our products (a electronic load). We used to use the INA240A2, but due to parts scarcity, we had to go for the alternatives…
Part Number: INA290-Q1 Other Parts Discussed in Thread: INA293-Q1 , , INA293 , INA290 Hi TI,
We like the improved quiescent current of INA290-Q1 with only slightly less nominal bandwidth. Is INA290-Q1 recommended for our automotive 48V DC-DC converter application…
Part Number: INA293 Other Parts Discussed in Thread: INA240 Dear experts,
could you please help me find out what could be the root cause for significant output voltage overshoot as seen on oscillograms below? Target application is INA293B3 (100x gain…
Part Number: INA293 Other Parts Discussed in Thread: TINA-TI Hi,
Customer is looking for Propagation delay response of this device, do we have data on this?
According to them, propagation delay is also quite critical in their application which it will be…
Part Number: INA293 Dear team,
My customer is also interested in the overload recovery time of the INA293 as has been asked on the following thread : https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1030897/ina293-saturation-to…
Part Number: INA293 Hi team,
Does the Input bias current variation Min, Typ, and Max mean an individual characteristic defined at manufacturing? Otherwise does it means the variation over temperature range?
I think the former is correct because the Electrical…
Part Number: INA293 Hi team,
My customer wants to know how is the plot of input bias current IB+ and IB- look like when it's in minimum and maximum, because it seems to be only typical value as started from 20uA. If it's in maximum value, just offset…
Part Number: INA293 Other Parts Discussed in Thread: LM7705 , OPA376 Hi expert,
Is there any method/circuit to make INA293 output can go as low as ground, not 0.02V swing to ground? Thanks.
Regards,
Jiandong