Part Number: INA300 Other Parts Discussed in Thread: INA303 , INA302 , INA301 Hi sir,
Would you please helping to check my customer's design about INA300? And they want to know the max error% about the result? Thanks for your kindly help.
Best…
Part Number: INA300-Q1 Hi team
The device has the hysteresis setting, but there are no max & min value.
In general, when they consider to design the hysteresis setting in worst case as the comparator, how should they design the system without the…
Part Number: INA226 Other Parts Discussed in Thread: INA300 , INA233 I would like to sense an output 98W (20V/4.9A) and should control in range 96W~100W by sensor ICs
Which is my chosen INA300/INA233/INA226
1. Can INA226 & INA233 do it?
2. How to…
Part Number: INA300 Hi Team,
Customer is designing INA300 on the type C monitor.
Would you please review schematic and provide comment?
txn.box.com/.../6od3shpk2qrhzbzfenmxafpwo7foahre
BR,
SHH
Part Number: INA300 hi Team,
customer using INA300 to detect an overcurrent and give an alert
the voltage across the Rsense will have charge current and discharge current. the INA300 is only required to detect the discharge over current event. …
Part Number: INA300 It looks like the INA300 IC starts-up in transparent mode.
Is there a way that you can start-up in Latch mode?
CH1 - Output current
CH2 - Alert signal
CH3 - Enable signal
CH4 - Latch signal
A) U10 starts-up in transparent…
Part Number: INA300 Hello,
Our customer asked about if INA300 ENABLE connecting to VS directly causes some malfunction and/or damaged during start up.
Would you please let us know if the customer will face on something abnormal ?
Best regards,
Hello Samet,
Thanks for considering to use Texas Instruments. Did you try running this in TINA-TI and run into similar issues? When I run the TINA-TI reference design, the model has no problem with vsense larger or smaller than vlimit. Could you share…
Part Number: INA300 The INA300 data sheet includes a Recommended Operating Conditions table that shows the recommended Common Mode input voltage as 12V.
Why is this listed as 12V?. The INA300 is spec'd to operate between 0V and 36V common mode range…
