Part Number: INA333 Hi Team, I have Pressure sensor Which gives 24mV/bar. I need mesure upto 2.8bar, Connected VCC=5V, VSS= 0V. REF =0.5V . Can you give Pressure vs output Voltage Calculation.
Part Number: INA333 Other Parts Discussed in Thread: ISO224 , AMC3330 Hello,
I am trying to measure voltages, it's three phases voltage (secondaries of VT - 100 to 120Vac phase to phase). As shown in the attached pictures, I use a voltage divider and…
Part Number: INA333 Hello, I am finding some discrepancy between the input common mode voltage range for the INA333 inamp described in the datasheet at page 10, fig 21 with respect of what I measure and see in simulation using the Tina TI software.
…
Part Number: INA333 Other Parts Discussed in Thread: TLV9062 Hello,
I am designing a single-supply (3.3 V) EMG (electromyography) analog front-end using INA333 and TLV9062. The goal is to amplify the EMG signal from an arm muscle and read it with a…
Part Number: INA333 Tool/software: Fig. 21 in the INA333 datasheet is generated with a VREF of 0V, will the output voltage just go up by 0.45V if I apply a 0.45V voltage source to the VREF pin? For instance, at input common mode of 4.5V in Fig. 21, the…
Part Number: INA333 Hi, According to datasheet, there is following specification. * PSR vs temperature : +/- 0.1 +/- 0.5/G On the other hands, there is following specification. Above figure show maximum value is "0.04". This value is different from value…
Part Number: INA333 Tool/software: Hi, I designed a RTD circuit with the help of INA333, Issuse is the output not varying linearly w.r.t Vdiff. please find the below images.
Additionally, when the RTD is disconnected, the difference between IN+ -…
Part Number: INA333 Tool/software: when the RTD is disconnected, the difference between IN+ - IN- is approximately 9.5V, it cause to damage IA's, Could you explain the cause of this and suggest how to protect the circuit under these conditions?
Part Number: INA333 Other Parts Discussed in Thread: INA826 Tool/software: Hello TI Team,
I intend to interface the 3 wire RTD with the INA333. Could you please suggest the design for it ?
I appreciate your feedback. Please revert asap.
-----…
Part Number: INA333 Hi experts,
Need advice on this one.
The simulation shows straight line but when the circuit was built, the output showed a sawtooth waveform instead. What could be the issue?
More information:
1. The oscilloscope probe…
