Part Number: INA333-Q1 Other Parts Discussed in Thread: INA333 , OPA333 Tool/software: Hello, I am currently testing my product under 0-400MHz - 100mA or 60mA - bulk-current-injection(BCI) test. I have an INA333 design for my product. You can see my design…
Part Number: INA333-Q1 Other Parts Discussed in Thread: INA333
Hello,
I have a design that uses the INA333 as the instrumentation amplifier and main gain stage for a relatively slow (<10Hz) but highly precise input signal. The input signal has a negative…
Part Number: INA333-Q1 Other Parts Discussed in Thread: INA333 , Hello, dear engineer;
The reason I use INA333: To measure the voltage difference induced on the coil. So the voltage difference will be very low. However, I have mentioned a few problems I…
Part Number: INA333-Q1 Other Parts Discussed in Thread: INA333 , OPA320 Hi team，
I am using INA333 for current sampling. The hardware Settings are as follows. The power supply of INA333 is +3.3V and -1V respectively.
When I increase VCC_LD, the voltage…
Part Number: INA333-Q1 Hi team,
Could you make simulation circuit and share it with me by Pspice for TI for lower circuit with INA333-Q1?
Regards, Ochi
Part Number: INA333-Q1 Hi team,
Could you tell me which EVM and how we use it for INA333-Q1 evaluation?
Is "INAEVM-MSOP8" suitable for INA333-Q1 VSSOP? Is it EVM without INA device and we need additional INA333-Q1 IC itself to evaluate INA333…
Part Number: INA333-Q1 Other Parts Discussed in Thread: INA333 Hi,
I use a INA333 to amplify a 0...20mV signal and measure the amplified signal with an uC ADC (5V_ADC_reference voltage). I use a gain of 101 and a reference voltage of 0.7V for the INA.…
Part Number: INA333-Q1 Other Parts Discussed in Thread: INA333 , Hi, Good day. I hope you are doing fine. Our customer wants to use the INA333-Q1 and they want to simulate it. As I've checked the product folder of INA333-Q1, I cannot find the PSpice model…
Part Number: XTR111 Other Parts Discussed in Thread: INA333 , INA818 , INA333-HT , INA188 , OPA2197 , OPA2192-Q1 , TLV2197-Q1 , OPA197 I would like to design a circuit, whose signal voltage is in the range -1mV to 11mV. This signal voltage should be converted…
