Part Number: INA351A Hi,
Please help to check our schematic diagram of the INA351ABSIRUGR, and the output is about 2* Vs and our require the G=10V/V, and we have no idea the error for the schematic, and please kindly review it, thanks.
The waveform…
Part Number: INA351A Hi -
Customer is asking how this part would behave if the signal input went beyond the supply voltage rails? Assuming the design stays within the absolute maximum ratings.
Would the output rail? Or go into a undefined state (cannot…
Part Number: INA351A Other Parts Discussed in Thread: INA351 Tool/software: hi Expert，
The INA351 uses a single supply of 1.8V power,add a offset reference power supply 0.8V to Pin 5,The schematic diagram and layout is as follows:
Adding a bias…
Part Number: INA351A Other Parts Discussed in Thread: INA114 Tool/software: Has anyone else reported any issues with these ASEL Assembly/Lot code Burr-Brown parts?
The voltage outputs using these parts are increased by ~100mV.
This is on a stable…
Part Number: INA351 The datasheet for the INA351 lists the GS pin as floating, Logic0 or Logic1. However it is unclear if Logic0 level is the negative power supply rail of the amplifier or ground, if a split rail supply is used. That is, for a Gain=10…
Other Parts Discussed in Thread: TL074 , TL071 , TLV9002 , TLV9004 , TLV9001 , TL074H , TL103WB , INA351 , INA351A I am using PSPICE for TI to simulate a preamplifier based on TL074. When I add the op-amps to the schematic, each unit appears as a separate…
