Part Number: INA826 Hi Teams,
The customer is currently using the INA826AIDR operational amplifier and has discovered an issue. According to the design in the diagram, the amplification factor should be changed to 150.7. However, it has been found that…
Part Number: INA826 Tool/software: It is the same as ina826 (sop-08) and has a semicircular direction mark. It says Ti 01 AFL, Tİ 06 AFL, Tİ 11 AFL. I could not find a datasheet about it on the internet. Can someone help me please?
Part Number: INA826 Other Parts Discussed in Thread: TINA-TI Tool/software: Subject: Help with AFE Design and Simulation for 0–42 mV Input Signal Using INA826
Hi TI Team,
I'm currently working on designing an Analog Front-End (AFE) to interface with…
Part Number: INA826 Other Parts Discussed in Thread: TINA-TI Tool/software: I recently updated to the new version of LTspice from LTspice 17.1.4, and the model for the INA826 instrumentation amplifier stopped being able to simulate correctly. I tried…
Part Number: INA826INA826AIDRGT in the datasheet its writen that the EP is connected internally to -V
But I measured it and it's not
I connected 15V to +V and -15V to -V and connected the EP to the 0V of same P.S. by mistake
if it was shorted internaly…
Part Number: INA826 Please help us urgently with the baking conditions for the MPN INA826AIDGKR .
It would also be helpful to know the following: How much can the shelf life be extended after baking?
Part Number: INA826 Tool/software: Team,
Posting on behalf of my customer. They are using TINA to simulate the INA826 ( circuit attached along with .tsc file), but the output doesn’t match with the gain equation as shown in the datasheet. Can you advise…
Part Number: INA826 Other Parts Discussed in Thread: ADS8689 , PGA112 , , PGA280 , INA350 , INA351 , INA333 , XTR200 Hi,
I am designing a single channel, single ended analog input that can handle 0/4-20mA and 0-10V. I am referencing most of my design…
Part Number: INA826 Tool/software: the transducer output DC2.5V+/- (0~2.5V), default 2.5VDC then connect to INA826 IN+, IN- connect to 2.5V REF， I want to increase signals 20 times as input, Vo= (Vin-Vref)*20 +2.5V(Vref), but it always output with 700mvpp…
