Part Number: INA827 Other Parts Discussed in Thread: OPA333 Tool/software: Currently designing a radar level gauge product The INA827 circuit was used, as shown in the following figure.
Now debugging has found that its differential frequency signal…
Part Number: INA827 Other Parts Discussed in Thread: INA823 , TMUX1108 , INA818 , TMS320F28379D Hello everyone, I currently have the problem that I want to record a signal with two different amplifications. I'm using the INA823 for the low gain and the…
Part Number: INA827 Tool/software:
Currently designing a radar level gauge product The INA827 circuit was used, as shown in the following figure.
Now debugging has found that its differential frequency signal output value is relatively small,
…
Part Number: INA827 Hi Team,
Do we have other device can P2P replace with IN827AIDGK? I have checked with IN826 and looks like some gaps in spec. Do you have any recommended device for replacement?
Thanks,
Gust
Part Number: INA827 Other Parts Discussed in Thread: OPA192 , LM324 , OPA325 , OPA191 , OPA391 Hi team
Good day
My customer have a question:
I have 3 INA827 instrumentation amplifiers , all the three reference pins are driven by a single buffer…
Part Number: INA827 Other Parts Discussed in Thread: OPA330
I am using the INA827 to drive a 5kg FMZK loadcell. And despite thinking we have the equations calculated correctly and our resistors set etc we are not seeing an accurate reading on the loadcell…
Part Number: INA827 Other Parts Discussed in Thread: ADS8684 , LM2904 Hi TI,
We're seeing some odd behavior while connecting an INA827 to an ADS8684. The attached, simplified schematic shows how we 1) take measurements from photodiodes 2) connect…
Part Number: INA827 Other Parts Discussed in Thread: OPA192
Hi,
I'm planning to use INA827 as shunt current sensor with Gain of 9.
VM2 is output of INA827. Simulated waveform's screenshot is highlighted for non-expected results (in red color…
Part Number: INA827 Hi All,
I am using INA827 along with load cell for my ADC frontend. I would like to calibrate my ADC using external mV source. How can I achieve the same? I have shared my ciruit below.
Thanks!
Part Number: INA827 I am attempting to use this instrumentation amplifier to amplify a DC signal that ranges from 0V to 114mV. This range does not give enough resolution for my data logger system. I built the circuit according to the typical application…
