Part Number: INAEVM Tool/software: Dear team,
Could you please provide the Gerber Data for INAEVM-SO8?
Our customer would like to incorporate this EVM to thier system.
so, they would like to know more INAEVM-SO8 Mechanical Drawing data.
Best…
Part Number: INAEVM Tool/software: Hello all,
Please provide the design data in Altium for INAEVM-SO8 (INA126UA). We need the schematic/Layout symbol. There are very basic symbols available on other sites available.
Thanks,
Nilesh S.
Part Number: INAEVM-SO8 Hi,
in order to implement an analog-to-digital conversion (input range of at least -6V to +6V) I wanted to check and survey some instrumentation amplifiers which are intended for driving the ADC. Therefor, I used the INAEVM-SO8…
Other Parts Discussed in Thread: INAEVM Precision Team,
I have a customer looking for the mechanical drawings for the INAEVMs. The UG does not include dimensions. Where can these be found or can you post?
INAEVM - http://www.ti.com/tool/INAEVM?keyMatch…
Part Number: INA116 Other Parts Discussed in Thread: INA121 , INAEVM Hi team,
I know that INA116 is a very old device. But is there any Gerber files available or recommended PCB layout for it?
Thank you.
Kind regards,
Aida
Hi Nader,
Please try the following EVM and it may get what you want.
https://www.digikey.com/en/products/detail/texas-instruments/TSSOP-VSSOP-ADAPTE/17884958
https://www.ti.com/lit/ug/sbou290/sbou290.pdf
Alternatively, please try the following…
Hi Henrik,
Henrik Rosenø said: But what's the difference between the https://www.ti.com/tool/INAEVM-ALT-SO8 and the https://www.ti.com/tool/INA826EVM ?
The https://www.ti.com/tool/INAEVM-ALT-SO8 is the alternative solution. Please review both schematic…
Part Number: INA826 Other Parts Discussed in Thread: TINA-TI , INAEVM-ALT-SO8 , INA821 I am designing circuit to measure microamps of esp32 in sleep modes. I am beginner in this field. I am thinking of using INA826 amplifier. It will be used as low side…
Part Number: INA333 Other Parts Discussed in Thread: TINA-TI Hi,
Recently, I tried few experiments by using Eval board: INAEVM-MSOP8 along with the INA333. In order to emulate the load cell (whose wheatstone bridge nominal resistance is 360 ohm) and…
Ben Southall said: And if I feed that into either my ADC or an op-amp, the input impedance should be very high and in a perfect world it's a voltmeter that has no effect on the internal system and is indistinguishable from an open circuit, so that impedance…
