Part Number: ISO124 Hello,
I am working on one 4 isolated channels board with 4 iso124. I select 2 x TB2-2423(2W) to supply iso124 high side and low side. I see iso124 high side and low side only need max 7ma, however, I got issue to power on board…
Part Number: ISO124 Tool/software: Is it possible to isolate a differential signal using two ISO124s?
please check attached file.
ic133 and ic135 are iso124.
input signal range (in0+ to in0-) is between ±5v and 0v.
if thera is a problem,tell me…
Part Number: ISO124 Other Parts Discussed in Thread: ISO224 Tool/software: CAN I USE ±10V INPUT SIGNAL UNDER the CONDITION?
+VS1 :5V
-VS1 :-5V
+VS2 :+5V
-VS2 :-5V
±VS1 AND ±VS2 are isolated.
Part Number: ISO122 Other Parts Discussed in Thread: ISO124 , LT1013 actually in my existing design i have used ISO100 ( TH ) , now reengineering the board and replacing with SMD alternate part ISO122 or ISO124 ( suggested in TI forum ) but after simulation…
Part Number: ISO122 Other Parts Discussed in Thread: ISO124 , AMC0211S , AMC1411 , ISO224 , AMC1400 , AMC3330 In a noisy industrial application i have a 4-20 ma and a -10 to +10 signal coming from sensors. I need to get these signals in a microproccesor…
Part Number: ISO124 Other Parts Discussed in Thread: TL071 Tool/software: Hello，
The customer uses ISO124 for signal isolation, as shown in the circuit diagram below. The signal is used to drive the frequency converter, with an input voltage of 0-10V…
Part Number: ISO122 Thank you for the previous guidance regarding the ISO100 to ISO122 migration
To correctly reproduce the original functionality, if LTSPICE/ SPICE model is available it could have been easier for me but as it is not available , could…
Part Number: ISO124 Tool/software: The ISO124 data sheet states that the "Initial offset" is +/-20mV typical.
What do they mean by "Initial" and how much time after the "Initial" period can the part be expected to drift?
I also need to know the magnitude…
Part Number: ISO124 Other Parts Discussed in Thread: OPA2990 , ISO224 , Hi Team,
I need you support for new design. requirement is taking potentio meter output to rc filter--->buffer opa2990 >> divider(1/8)---> ISO124U ---> ADC PIN OF MCU.
Supply…
Part Number: ISO124 Other Parts Discussed in Thread: AMC1411 , ISO224 , AMC1400 Hello:
Can I connect VS1- to GND1? I want to use a single power supply.
Below is my circuit diagram
