Hi Wei,
I would just like to confirm a few points regarding the schematic;
HMI with 927 Serializer --> Connect to 940N EVM --> Good LOCK and PASS HMI with 927 Serializer --> Connect to custom layout 940N (schematic above) --> No LOCK or PASS
From…
Part Number: DRV8353RS-EVM Tool/software: i am running my BLDC motor with DRV8353RS EVM kit with ISO-F28027f MCU board and i am controlling the motor with DRV8353Rx GUI. But when i start my motor then motor starts rotating but the fault led remains on…
Hello,
Thanks for the quick update.
This shows that no inputs are being sent from the MCU.
Double check your hall sensors and make sure that they are connected correctly.
I assume you have the board mounted correctly, but double check that just…
Part Number: PROCESSOR-SDK-AM62P Tool/software: TI provide us a the 1st splash screen fast boot measurement report based on TI EVM board with SD Card+Nor in Linux: Early Splash Screen With Flicker-Free Transition
After I go throug the HMI fast boot…
Jiaqui,
You can redesign the coil and attach it to the EVM.
You can design a new sense coil using our Excel-based Inductive Sensing Design Calculator Tool . You will most likely need to change the resonating caps that are in parallel with the sense…
Hi Gokul,
Gokul S said: after generating the header file include that in app_iss_common.c enable this flag sensorObj->sensor_dcc_enabled=1 in application, then this function configure_dcc_params(vx_context context, LDCObj *ldcObj, SensorObj *sensorObj…
Part Number: TDA4VM
Tool/software:
Hi team,
I'm working on SDK 08_02_00_05(Linux+RTOS).
When testing a application, I'm facing the below error log.
root@j7-evm:/opt/vision_apps# ./btc_tpa_dl.out --cfg btc_tpa_dl.cfg
APP: Init ... !!!
MEM…
Part Number: TMAG5233 Other Parts Discussed in Thread: TMAG5134 , TMAG5133 ,
Tool/software:
xMR is a term which generally describes any form of magneto resistive sensor. This includes anisotropic magnetoresistance (AMR), giant magneto resistance (GMR…
Kaan Berke Ulusoy said: I have set it to 3840 x 2160. I did it when you first mentioned about it.
However, I still got the problem.
I suppose you would only need to modify these 3 lines in single-cam app to match your actual LDC settings in DCC. …
