Part Number: LF353 Tool/software: Dear Sir/Madam,
I've been ordered the subject product under order no. T01447754 with DC: 2021 on 17 Jun 2021 which the country of origin is Mexico.
Being used of the mentioned products in several years, my customer…
Part Number: LF353 Tool/software: Hi
The Pin01&07 output of NG products is 20~30mV lower, while the output of good products is 70~90mV
LF353DR stk.pdf
LF353D.docx
Part Number: LF353 Tool/software:
We currently use the LF353DR operational amplifier for amplifying differential signals. We have tested the differential signal input at 0.127V and amplified it by 1.8 times. The calculated single ended signal should…
Part Number: OPA1652 Other Parts Discussed in Thread: LF353 , , OPA4172 Tool/software: Hi,
We have a legacy design with a differential mode op-amp that uses LF353. We have high CM noise input to the differential circuit and we only care about DC input…
Part Number: LF353 Hi,
I'm using several thousands of this opamp.
For a new project I need an equivalent component which has an operating range at least from -20°C to 85°C. Unfortunately LF353 has a range from 0°C to 70°C.
Is there an "industrial…
Part Number: LF353 Other Parts Discussed in Thread: MC1458 , PGA204 , LT1013 , LT1014 , LM211 , LP211 , LM239 , LM3302
[Case:710026]Technical Data Inquiry
SiliconExpert is contracted by our customer to work with their suppliers for accuracy and compliance…
Part Number: LF353-N Other Parts Discussed in Thread: LF353 hi,
what is the recommended operation Vcc range? From Figure.5 in datasheet, does it mean that the VCC range +-5Vmin----+-18Vmax?
Part Number: LF353 As shown below, I used the LF253 and the OPA2354AIDDA to build a voltage sample circuit, which is used on a grid-connected inverter for the line-to-line voltage. Unfortunately, the result is unsatisfactory. The BDin0 port is connected…
Part Number: LF353 Other Parts Discussed in Thread: TL052 , TL072H , Hi,
I would like to know if there is any difference between LF353D and LF353M in terms of input offset voltage.
The input offset voltage specifications from datasheets seems to be…
