Part Number: LMX2594 Tool/software: The recommended input voltage range for INPUT SIGNAL PATH (OSCin) is listed to be 0.2 to 2.0Vpp. What is the absolute maximum voltage range for OSCin path ?
Part Number: LM2594 Other Parts Discussed in Thread: LM2674 , LM2574 , Looking to simulate an LM2594 design, but WEBENCH is not offering it as an option. Is there something I'm missing? It does offer LM2574, however I've got an existing design that uses…
Part Number: LM2594 Hello, the LM2594 voltage starts to sag under load, replacing the catch diode with a schlocky, appears to correct the sag, allowing the PCBA to operate normally
Can the output current be increased to 400mA by replacing the 220uH…
Part Number: LM2594 Dear,
During start up, a short overvoltage appears at the output, cca 1V/3ms above 5V. The input voltage is 24V/+-10%. What is the reason for overvoltage? How can this be solved? Thanks in advance for the suggestions. Best regards…
Part Number: LM2594 Hi Team,
My customer was reviewing the LM2594M-5.0, and they are trying to assess if the device is solder temperature sensitive. They had a few questions that I wanted to see if someone from the team can address:
Per the TI datasheet…
Part Number: LM2594 Other Parts Discussed in Thread: LMX2594 On the evaluation board, we can confirm the phase noise in Fig. 2 with the loop filter in Fig. 1 (almost agrees with the simulation).
With the loop filter in Figure 3, the result is Figure…
Part Number: LM2594 Other Parts Discussed in Thread: LM2595 Hi Team,
We have a customer planning to use two LM2594. He plans to connect the outputs (load side of the coil) in parallel. The first LM2594 will be connected from an external power source…
Part Number: LM2594 Hi Expert,
my customer found a strange phenomenon on LM2594 OCP test.
According to difference output current to trigger the OCP point, the drop of output voltage is difference, please refer attached waveform.
when load current…
