Part Number: LM2901B-Q1 Other Parts Discussed in Thread: LM2901 , TLV1805-Q1 , TLV1704-Q1 , , LM339 Hi Experts:
It set VCC of LM2901 is 9~16V, IN+ =VCC/2 :
When IN- is equal to VCC-0.7V,is the out`pin output high?
When IN- is equal to 0V,is the…
Part Number: LM2901-Q1 Dear expert, We will be using the LM2901-Q1 IC for our project but we need below parameters:
Failure Mode Distribution
Pin FMEA
Can you provide parameters above?
Your help would be appreciated. Best regards, tatsuya yanagida
Part Number: LM2901-Q1 Other Parts Discussed in Thread: LM2902-Q1 , , LM2901 , LM2902 Hello TI Team,
We use the component for voltage regulation of a power supply.
I would like to know if the device has a over-load protection like hiccup or latch protection…
Part Number: LM2901-Q1 Hello Sir:
We are using LM2901-Q1 to design on our CVT controller.
Can you share the FMEDA document of LM2901-Q1 ?
We need it to finish our FMEDA data.
Looking forward your feedback.
Thanks a lot.
Part Number: LM2901-Q1 Other Parts Discussed in Thread: LM2901 , LM339 , LM393B Hi,
During simulation of LM2901QPWRQ1 using LM2901.5_1 Pspice model in OrCad, following was observed.
Even if both the inputs at inverting and non-inverting terminals are out…
Part Number: LM2901-Q1 Other Parts Discussed in Thread: LM2901 Hi Team,
My customer has the design which using two LM2901-Q1 as the current protection solution. Below is the schematic: The CSA is the detected signal from current sensor, and the plot upper…
Part Number: LM2901-Q1 Hi Team,
Customer would like to know is there any problem with the signal amplitude at the input of the comparator exceeding the power supply of the comparator?
U i has only two states:
Floating, at this time, the input voltage…
Part Number: LM2901-Q1 Other Parts Discussed in Thread: LM2901 Tool/software: TI C/C++ Compiler Hi I'm chatbot
I want ask about LM2901-Q1.
Datasheet of LM2901-Q1 tells "Positive input is higer than negative input then LM2901-Q1 sink current"…