Part Number: LM324LV Other Parts Discussed in Thread: ADS1115 Tool/software: Hi,
I am designing a photodiode amplifier circuit by referencing to this document .
This is my schematic.
(I set the V_OFFSET to 0.1V using resistor.)
I prevented light from…
Part Number: LM324LV Other Parts Discussed in Thread: ULN2003LV Dear Team,
May you give some TI suitable solution to replace MMBT3904?
ONSEMI,MMBT3904
Many Thanks,
Jimmy
Part Number: LM324LV Other Parts Discussed in Thread: LMV324A , LMV324 , LMV324-N , TINA-TI , TLV9004 Hello team,
I have question about full swing output voltage with open-loop. The our evaluated schematics is using V+=5V,V-=GND, Load =about 20Kohm. It used…
Part Number: LM324LV Hi, What would be the output voltage level when VCC removed from the LM324LV in Voltage follower mode.
Conditions:- Non-inverting pin input voltage - 0.8V and VCC 0V (OFF).
Jebin
Part Number: LMV324A Other Parts Discussed in Thread: TLV9004 , LM324 , LM324LV , LMV324 Is it bandwidth? Power consumption?
Please let me know
Thanks in advance
Mike Newell
This is documented in the Application Design Guidelines for LM324 and LM358 Devices . The range becomes worse at lower temperatures, with about 4 mV/°C.
In low-voltage applications (≤ 5 V), you should use low-voltage opamps with a better VCM range…
The worst error happens when A1 has a negative offset (−7 mV) and A2,A3 have a positive offset (7 mV), and when R3,R4 are too small and R1,R2,R5,Rf are too large.
With all resistors 10 kΩ ± 50 Ω, and Rg = 2222 Ω for G=10, a differential input of…
Anurag,
The simulation as provided ran for me, however I'm not sure what you are attempting for the design. The amplifier is being driven out of the linear range, which is likely why you are getting convergence issues.
Your output is saturated and…
Hey Tanmay,
Do you have an example schematic for the application? Is swing and cost the only concern in this case?
Have you considered the LM324LV? The output swings to 40mV from the negative rail and has an upper output swing limit of 1V from supply…
