Part Number: LM339 Hello,
I have an overvoltage protection (OVP) in a 380V power supply. Overvoltage protection is at 420V. This power supply does not have a 380V discharge circuit so the output still discharges slowly when the output is turned off…
Hello Nitish,
Don't confuse Min and Max and Typ..
The 16mA is a "typical" value, as it is in the 'TYP" column. Typicals are not guaranteed.
Because the 6mA is in the "MIN" column, it means 6mA is the MINIMUM amount of current we guarantee the LM339…
Other Parts Discussed in Thread: LM339 , LM358A Hello,
I have an induction heater circuit with operational amplifiers LM358A and LM339.
The induction heater circuit consists a bridge rectifier, IGBT, PWM controller + MOSFET module, LC tank circuit…
Other Parts Discussed in Thread: LM339 , LM358 , LM393-N , LM393 Customer will connect unused channel of LM358 and LM339 (please see below), is this correct?
※VIN+：+15V, VIN-：GND
Customer is already made these circuit, they doesn't want to change…
Other Parts Discussed in Thread: LM339 hi
i want to use this device (LM339) as an op amp, my circuit look out as below,
please let me know your email so that i can send you the sch.
When have built this simple circuit to experiment, in the simulation…
Other Parts Discussed in Thread: LM339 Hi all, Would you mind if we ask LM339? <Q1> About Vicr, the datasheet shows that Vicr range are "25°C 0 to Vcc–1.5", "Full range 0 to Vcc-2.0". So, IN+ and IN-(both) must satisfy this range, mustn't they? <Q2> Input…
Other Parts Discussed in Thread: LM339 I have a circuit that has been in use for years and in at least 100 units, but there have been one or two returned for repair that seem to have a faulty LM339 at the root of their problems. The circuit is a latching…
Other Parts Discussed in Thread: LM339 We use LM339 for the protection function. The VCC is 12VDC and GND is connect to system ground. Since our IN+ will have negative voltage input, around -0.5V. I would like to know this -0.5V will be damaged the IN…
