Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: LM6134 Other Parts Discussed in Thread: OPA4992
[Case:711717]Technical Data Inquiry
SiliconExpert is contracted by our customer to work with their suppliers for accuracy and compliance.
Please advise if we can consider that "LM6134BIM" is…
Part Number: LM6134
[Case:711717]Technical Data Inquiry
SiliconExpert is contracted by our customer to work with their suppliers for accuracy and compliance.
We have an agreement with you that all NRND parts are set to have 10-15 Years, and we already…
Part Number: LM6134 Other Parts Discussed in Thread: LM6132 , TM4C123GH6PM Hello TI, I am using LM6134 and LM6132 Op-amps in my design and as a part of improvement a circuit is to be designed where the voltage on the Op-amp's input pins is 5V-15V but available…
Part Number: TLV9064 Other Parts Discussed in Thread: LM6134 , LM6132 , , OPA4197 , OPA4192 Hello guys,
I am currently evaluating an alternative to the LM6132 / LM6134 code with the following requirements:
Package TSSOP 14 pin (quad-OPAMP)
5.5V voltage power…
Part Number: LM6134 Other Parts Discussed in Thread: LM6132 Hi guys,
I hope all is fine!
I wanted to kindly know where to find the tOR Overload recovery time for the LM6134.
On the datasheet LM6132 / LM6134 the value of tOR Overload recovery time for…
Part Number: LM6134 Hey,
I am using LM6134B opamp and doing simple tests. Surprisingly, I found a strange behaviour, for which I am trying to find the reason. I am applying a ramp wave from 0 to VDD at the non-inverting input. I am connecting both VDD…
Hi Kai, Paul,
Before I create a test PCB, I have build a test setup on a breadboard.
To test the first stage op-amp and to check the piezo signal I used an LM6134 (had nothing available in DIP package)
Two things which I noticed on the scoop (see below…
Deepak,
I see two problems.
1) The LM339 common mode range does not include VCC+ 2) The comparators need an offset of about 15mV added. So 0mV input is off and 30mV is on.
High voltage (>6V) comparators with rail to rail (or VCC+) common mode range…
