Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: LM6171 Tool/software: The ±100V square wave signal from the Ultrasound Pulser is distorted as it passes through the cable.
The longer the cable, the more severe the distortion becomes.
I think the current of the Drive IC is insufficient…
Part Number: LM6171 Hi TI Teams,
The LM6171BIMX/NOPB has been discontinued and the LM6171AIMX/NOPB is recommended as a replacement parts.
Electrical Characteristics of LM6171AIMX/NOPB is Upper Grade.
Do LM6171BIMX/NOPB and LM6171AIMX/NOPB use the same…
Part Number: LM6171 Hi Team,
my customer reported that the spice model of LM6171 slowed down his simulation speed significantly.
Would you have a more simplified version of the LM6171 model? If this is not available, any suggestions on how to improve the…
Part Number: LM6171 Other Parts Discussed in Thread: THS3122 , THS3491 , OPA197 Hi Sir/ Madam,
we are intended to use this op-amp for our project requirements. Project requirement is as follows.
1) output voltage required = 20 Vpp
2) Max input voltage available…
Part Number: LM6171
Hi team,
The customer is using LM6171BI for the integral circuit application. He uses two LM6171 devices. The input signal is the sine with amp=1Vpp,
f=5KHZ. The power supply is +/12V. He measures the output signals through the oscilloscope…
Part Number: LM6171 Other Parts Discussed in Thread: THS4631
Hi TI expert, My question is a follow-up of the one in thread e2e.ti.com/.../732403 . In that thread, kai klaas69 tells me the reason why the op amp –based integrator has an obvious response…
Part Number: LM6171
Dear TI experts，
Simple question: I’ve used LM6171 as a non-inverting integrator and its output is buffered by parallel connection of several push-pulls as Fig1. In my experiment, the waveforms of G2 follows G1 very well(Their rise…
Part Number: LM6171 Other Parts Discussed in Thread: IVC102 Hi,
I have use the LM6171B for integrating a sinusoidal signal such that I can vary the amplitude and frequency of the input signal. The circuit which I have attached here is from TINA and for…
Other Parts Discussed in Thread: LM6171 Dear Nikhil,
I have downloaded the PSpice model for LM6171 and imported it into ADS. The problem i am facing is unclear pin numbering of the Op-Amp. I can't see which pin is which, i mean V-, V+, IN-, IN+ and output…
