Part Number: LM7171LM7171 oscilates at 28MHz.
Netlist is as following.
According to the datasheet, would it be better to place a 2pF Capacitor in parallel with the 820ohm resistor between 2 and 6, or change the 10ohm output isolation resistor between…
Part Number: LM7171 Hi Team,
Here is the circuit diagram that has been provided in the ATE Hardware setup.
There is a 50 ohms isolation resistor in the output pin of LM7171. (As per the recommendations given in datasheet in order to overcome the…
Part Number: LM7171 Other Parts Discussed in Thread: THS4631 Tool/software: I need to buffer a 0V to 16V sine wave (16V peak to peak with +8V offset) into a cable while minimizing loading on the signal source. I tried the THS4631 and LM7171A as unity…
Part Number: LM7171 Tool/software: Hi, I used an LM7171BIN op-amp to amplify my source, but it doesn’t seem to work.
I have a 150 ps laser pulse detected by a PDA10A2 (Thorlabs). A 5 MHz low-pass filter (Mini-Circuits SLP-5) is then connected to the…
Part Number: LM7171 Hello Experts,
The Spice Model for LM7171 is wrong. The simulaor cannot run with this model. Can you please revise the simulation model.
Here is the error which I found.
The pin does not match between spice model and the datasheet…
Part Number: LM7171 We're attempting to replace the MSK0032/LH0032CG (U9) with the LM7171 and we're running into issues in the 100kHz to 500kHz range. It looks like it's capacitive loading. Please take a look at the attached image and see if there's anything…
Part Number: LM7171 Other Parts Discussed in Thread: LM6171 ,
Hi team,
customer use our LM7171B for RF amplifier for 1.5MHz input sine wave,
and expect for voltage sinwave larger than ex. +-5V , they expected output will stops as input stops,
…
Part Number: LM7171 Tool/software: Customer is looking for -55 or lower storage temp for LM7171AIMX/NOPB. The spec is not in the datasheet. Can this device have a storage temp of -55C or lower?
If NO, then is there a newer alternate device that can…
Part Number: LM7171 Hi,
I am using LM7171 for laser application but hope to get rail to rail amp.
Is it possible to recommend rail to rail product equivalent GBW of LM7171?
I checked High-speed amps lineup but it might have max 100MHz.
I am going…
Part Number: LM7171
Tool/software:
Hello all,
We needed to create a circuit capable of fanning out a 50 ohm TTL pulsed DC to 16x 50 ohm loads. Each output requires a rise time ~ ones of nanoseconds and power sourcing capability of ~ 1W peak output…
