Part Number: LMC6035 Tool/software: Electrical Test Init (U3D-)
Encounter 4 units that failed Electrical Test Init (U3D-) during functional test. Measurement of the U3D- voltage is out of spec
Unit
Serial Number
Test Results…
Part Number: LMC6035
Hello technical support,
Could you help me to check the bottom view of chip ?
We have found that wafer fab GF6 and GF8 will have a different bottom view.
Is the logo circled with a red square refer to the wafer fab GF6?
…
Part Number: LMC6035 Folks,
I have a question regarding the maximum sink/source current or the LMC6035.
The Abs Max table suggests that the maximum output current is +/-18mA with 30mA as an acceptable short-term value (note 5).
Though…
Part Number: LMC6035 I am trying to utilize the LMC6035 as a non-inverting gain amplifier. I have the circuit seen below (bypass cap present in design but not shown). I have a stable 1V DC signal on pin 5 of the LMC6035, and I want a stable 5V output…
Part Number: LMC6035 Other Parts Discussed in Thread: DIYAMP-EVM Team,
my customer is asking for samples and EVM for LMC6035ITL (DSBGA package). The universal OPAMP EVMs (such as OPAMPEVM) are not suitable for this package.
Do we have any solution…
Part Number: LMC6035 Hello experts,
I would like to know whether LMC6035 can operate a following range or not.
V- = -3.5V V+ = +3.5V
The datasheet mentioned it can be used a single power supply, so I would like to know whether LMC6035 can be used…
What is the limit on the bias current? (And what offset voltage, GBW etc. do you need?)
The unity-gain stable opamp with the smallest bias current is the LMC6035, according to the search function .
I did find a way to cut traces and solder in some 36 AWG wire to route the single-ended input to IN- and the AC GND to IN+.
It did not immediately fix the problem. All of the audio testing is subjective, so there could have been some improvement (i…
