Part Number: LMC6492 Other Parts Discussed in Thread: LM2904 , OPA333 HI.
Wien bridge oscillator circuit using LMC6492 is as follows.
However, there are cases where it does not actually work, and there are cases where it does. (Even when LMC6492…
Part Number: LMC6492 I have created a simple non inverting voltage follower with single supply of 3.3 V. I have created two cases of input voltages. Case 1: AC Amplitude 0.25 mV, Case 2: AC Amplitude 1 V. Both cases are working at a DC Offset of 1.25…
Part Number: LMC6492 Please provide the thermal resistance Rtheta_JC for the LMC6492BEMX. The Rheta JA is provided in the datasheet but not the Rtheta JC
The question was already asked / provided here:
https://e2e.ti.com/support/amplifiers/f/14…
Part Number: LMC6492 Regarding part number: LMC6492BEM/NOPB
I need the thermal resistance of the package. Specifically I need the theta JC (junction to case) or the theta JB (junction to board) thermal resistance.
Thanks
Part Number: LMC6492 Hello team,
I have an inquiry from customer about IC specifications.
The minimum supply voltage for this device is V + = 2.5V in the operating condition table. However, all parameters in the DC and AC electrical characteristics…
Hasan,
Trying to force more current into VBUS than VBUS wants to draw will only cause VBUS to increase in voltage. Higher voltage is not good for the system. If you get 9V to the Note 5 (after it asks for it) and it draws 1.23A instead of 1.67 Amp…
Jason,
I apologize for the delayed response.
LMC6492 has a max IIB of 200pA so I don't recommend this one. Look for low 25C maximums for IIB. Look for typical IIB vs temperature charts.
Low Vos is nice to reduce DC voltage error and reduce guard…
Hello Anuraj,
The LMC6492 is the extended temperature range (-40 t o125) of the LMC6482. Basically the same device, but the limits are slightly wider due to the wider temp range.
Part Number: LMC6082 Other Parts Discussed in Thread: LMP91000 , LMC6081 , , LMC6482 , LMP2232 , LMC6492 Dear Forum,
I am currently trying to design a dissolved oxygen device using a 2-wire polarographic probe. The max output of this probe is roughly…
Other Parts Discussed in Thread: OPA379 , OPA350 , LMC6492 , LMC6482 , OPA340 I built a multiple feedback 2kHz band-pass filter with gain Vo/Vi = 4 and an envelope detector for this filter as shown in this great video tutorial EEVblog #490 - Peak Detector…
