Part Number: LMH6559 Other Parts Discussed in Thread: BUF802 Hi,
We are looking a P/N for Analog Buffer part, we have the reference of LMH6559 in terms of voltage gain, accuracy and distortion. But we need faster part than LMH6559, where the seetling…
Part Number: LMH6559 Other Parts Discussed in Thread: TINA-TI Seeing several milliamps of input bias current instead of microamps at 400MHz in simulation. Is there a non-specified relationship between frequency and bias current or is it an issue with…
Part Number: LMH6559 Thanks a lot to Sean for answering the last question about LMH6559 typical schematic.But I still have some questions.
1.How does the coaxial cable connect to the conductor at the cross 1、 2、 3 with the red mark? Is it to strip the…
Part Number: LMH6559 Other Parts Discussed in Thread: OPA656 , OPA2837 Hello everyone
I use LMH6559 to assure that the excitation signals have low impedance.But refer to LMH6559 datasheet ,I still can't determine the circuit structure. I hope you can…
Part Number: LMH6559 Under the packaging information the first listing for a LMH6559MA indicates NRND. This is only for the first listing, not the remaining listings. I want to use a LMH6559 for a new design. Is this a valid choice? If not is there a…
Part Number: LMH6559 Other Parts Discussed in Thread: BUF602 Hi team,
Can you confirm if the LMH6559MF supports the 1PPS signaling?
Thanks in advance.
Regards,
Renan
Part Number: LMH6559 Hi all,I use LMH6559 to assure that the excitation signals have low impedance
And I have some questions about LMH6559 Typical Schematic
1.What does the oval marked by the red box mean?
2.In AC circuit, it is necessary to have…
Part Number: LMH6559 Hi all,
I’m trying to make sense of the noise specifications in the datasheet for the LMH6559. In the table on page 3, the noise for +/-5V power supplies is reported as 5.7nv/rtHz@1MHz. But, in Figure 17 on page 11, it is much lower…
Hi Jehangir,
If you are only planning to buffer the 500MHz to 1GHz -40dBm noise spectra that is riding on top of the 0-1.8V low frequency clock signal, then I think operating the LMH6559 in dc coupled mode and +/-5V supply should be okay. However, I…
Other Parts Discussed in Thread: LMH6559 Dear All,
When I am trying to open the “LMH6559” Footprint via the Ultra Librarian reader (6.4.202). It was prompt following error message
“This footprint does not exist in the current library, or the component…
