Other Parts Discussed in Thread: LMH6642 , LMH6618 I would like to know the typical, min & max forward voltages for the internal ESD diodes on the inverting and non-inverting input pins.
Kind Regards,
Marc
Part Number: TLV3541 Other Parts Discussed in Thread: LMH6618 , LMH6611 Tool/software: Hello guys,
One of my customers is facing to mass-production of their new product which uses TLV3541DBV.
They realized that if TLV3541DBV package height is the…
Hi,
I see we don't have a spice model available for DAC5662 which can be simulated in TINA-TI. Sorry for the inconvenience caused.
Regarding LMH6618 & OPA355 you can get the spice models under "Design and Development" Tab of respective part number…
Hello,
Here is some information on the LMH6618 for you:
It’s a bipolar process with around 50-100 active devices.
Hope this is adequate for your needs.
Regards,
Hooman
Hello Sampath,
The 1KHz low pass filter is not going to help since the dc offset is at very very low frequencies. I suggest using a part like the LMH6618. The dc offset of this part is much lower, around 1mV. Also, the bandwidth of this part is sufficient…
Hello Jin,
The numbers are actual input voltage as a single supply application. Figure 60 confirms this.
The upper common mode limit is about 1.2V below V+, which is typical for this series.
Typicals are the average at room temperature and are NOT…
Hi Eli,
The closest parts to MAX4180 would be LMH6723 and LMH6618 (SOT23 package).
LMH6618 has shutdown (like MAX4180) but it is slower and has lower slew rate as well. LMH6723 does not have shutdown but has higher speed at about the same power…
Other Parts Discussed in Thread: OPA835 , OPA836 , OPA2889 , THS4281 , OPA890 , LMH6618 , LMH6645 , OPA683 , LMH6723 , OPA684 do you have suggestion part to replace LT6233-10?
Hi all,
I am designing a peak detector to give the output voltage to an analog input of the Arduino DUE (runs the pins at 3.3V). Looking at the circuit, the first diode is a Schottky model with which I practically eliminate the negative part of the…