Part Number: LMH6629 Hello,
Could you please describe how to measure the plot of Noise Figure (dB) VS Rs. For example, the Figure 58 of LMH6629.
Thank you very much
Best regards
Kailyn
Part Number: LMH6629 Hi
According to 10.2 Layout Example in the datasheet, the evaluation board is 4 layers stack up.
I would like to clearly identify the tracing and every layer before a board fabrication
Could you please help to confirm…
Part Number: LMH6629 Hi E2E,
Good day. Our customer is requesting for the thermal details Theta JC and Theta JB of LMH6629 in WSON-8 DAP package. The datasheet only provided the Theta JA. Thank you in advance for your assistance.
Regards, Carlo
Part Number: LMH6629 Other Parts Discussed in Thread: TINA-TI , OPA855
I am trying to use LMH6629 for low noise tranimpedance amplification. In the brochure, an example of Vout = 3VDC - 1200 ID is given. I have a few questions:
1. I wonder how to…
Part Number: LMH6629 Hi,
I am designing a circuit using two stages of LMH6629 with +/-2.5V supply to amplify the signal from a "Silicon Photomultiplier" optical sensor. The typical signals of interest will be 1-10 mV, however rare signals up to 7 V…
Part Number: LMH6629 Hi,
I was wondering if there is a mention of what is the voltage drop and the RMS noise contribution i n the Op-Amp as we increase the current draw (by reducing load resistance) in the datasheet. I was only able to find this graph…
Hi Wilbur,
Unfortunately we don't have an ADS package for the LMH6629, but I believe you should be able to inport and use the spice model in ADS.
Regards,
Hey Robert, your images did not come through - use the little paperclip in the ribbon to insert files - hopefully a TINA file - but,
The LMH6629 and BUF602 are not RR out, watch their headroom requirements.
