Search tips
Showing 70 results View by: Thread Post Sort by

  • LMH6702: Opamp

    TI Thinks Resolved
    Part Number: LMH6702 How to eliminate output offset voltage ?

  • LMH6702: LMH6702

    TI Thinks Resolved
    Part Number: LMH6702 lmh6702.docx

  • LMH6702: Looking for a SPICE model for the LMH6702

    TI Thinks Resolved
    Part Number: LMH6702 Good afternoon, I am trying to locate a SPICE model that I can import into an OrCAD simulation, I only see the TINA model on the TI website for this part. I remember simulating this part previously (few years ago). Can someone point…

  • LMH6702: Sink / Source Capabilities

    TI Thinks Resolved
    Part Number: LMH6702 Other Parts Discussed in Thread: OPA695 Hi Team, Just want to confirm, the LMH6702 can sink current as well as source, correct? +/-50mA Thanks, Mitchell

  • LMH6702: what is a good video buffer op amp with less than 2 ns propogation delay?

    Part Number: LMH6702 Other Parts Discussed in Thread: OPA693 , OPA695 I need a video buffer op amp for a 100 mhz signal. Main issue is I need less than 2 ns propagation delay, or 1 ns delay for a zero to 1 volt signal. I am using the step response curves…

  • LMH6702: Information about Noise versus temperature for LMH6702

    Part Number: LMH6702 Other Parts Discussed in Thread: OPA695 Hi, I have a question about noise for the LMH6702. I would like to know if there is any data for voltage noise, inverting noise current, and non-inverting noise current for temperature being…
    • Answered

  • LMH6702: Interfacing LMH6702 with DAC5681Z

    Resolved
    Part Number: LMH6702 Other Parts Discussed in Thread: DAC5681Z , , THS3217 , THS3215 , THS3491 hi, I am interfacing Dac5681Z with LMH6702 .Output required is 0v to 3v Unipolar. PL confirm whether circuit attached will work. Thanks Seema BEL_LMH6702.tsc DAC…
    • Resolved
    • Answered

  • LMH6702: LMH6702 - bottom marking

    Resolved
    Part Number: LMH6702 Hello Team, in the device datasheet there is the device marking description related to the top side of the device. The top marking as per datasheet is A83A (SOT 23 package) There is no reference for the bottom marking. What does it…
    • Resolved

  • RE: LMH6702: Noise model for LMH6702

    I do not have such an excel file. Noise is measured in RMS, since it is a Gausian, and the peak to peak noise is proportional to the amount of time included in the measurement. Best regards, Sean

  • LMH6702: VIDEO OUTPUT INTERFACE

    TI Thinks Resolved
    Part Number: LMH6702 Other Parts Discussed in Thread: DAC5681Z , THS3217 , THS3215 DAC_SCH.pdf hi, Please confirm whether above schematic will give output of 0 V to +2.5V. Pin 2 should be connected to neg supply or ground for unipolar positive output? …

Didn't find what you are looking for? Post a new question.