Part Number: LMH730316 Other Parts Discussed in Thread: LMH730216 , , DUAL-DIYAMP-EVM We are designing an instrumentation amplifier based on the LHM6703 SOT-23-6. There was a previous request for the LMH730316 gerber files. TI replied that they didn't have…
Part Number: LMH730316 Other Parts Discussed in Thread: LMH730216 Hi,
Is it possible to get a copy of the board design files or at least the gerbers for the LMH730316 eval board?
Thanks,
-Levi
Hi Lisa,
You are way ahead of me. Sorry. I had not noticed that the metric and imperial sizes are different!!
These components look to be either 1806 imperial (4.5mm x 1.6mm) or 1206 (3.2mm x 1.6mm). I think either one would fit the footprint. I'm assuming…
Hi Danilo,
Danilo A. said: The LMH6703MA/NOPB datasheet suggests putting the RF and RG resistors on PCB side opposite the IC, but the LMH730216 doesn't allow that.
Well, following the layout recommendations and mounting advices is crucial here. I think…
Hi BR,
You can buy a high speed sot-23 evaluation board here, www.ti.com/.../lmh730316 , and populate it with an LMH6629 configured for this high gain. Does this resolve your issue?
Best regards,
Sean
Other Parts Discussed in Thread: LMH730316 , LMH6702 , LMH730227 , LMH730216 , LMH6629 Hello,
Is LMH6702(SOT23 PKG) datasheet specification tested with LMH730316? At the customer evaluating of LM6702(SOT-23) with LMH730227, the distortion data is worse about…
Hello Paul,
I'm not very familiar with OPA355 and the possible overshoot causes, so I won't make any comments. However, you should be able to use the SOT23 EVAL from other high speed amplifiers (e.g. LMH6629, etc.) for this device. The Enable…
Hello Vladimir,
I've made some input impedance measurements for the LMV7219 (Vs=5V):
Rin = 750kohm
Calculated by measuring the input 1kHz sine wave amplitude drop / voltage division through a 93kohm series input resistance
Cin= 2.3pF
Calculated…
Other Parts Discussed in Thread: LMH6629 , TINA-TI , LMH730316 Dear colleagues,
The LMH6629 has been configured as Trans impedance amplifier with the following conditions:
photodiode capacitance 12pF
Feedback resistor 1.36K ohm
Non-inverting input grounded…
