Part Number: LMK00304 Other Parts Discussed in Thread: LMK00338 , LMK00334 , LMKDB1104 Hello,
I am working on a PCIE clock distribution design for our new network switch board. I have the following requirements: - common clock design - support a mix of Gen…
Part Number: LMX2595 Other Parts Discussed in Thread: LMK00304 , , LMX2572 Hi I want to use LMK00304 as an input buffer to two numbers of LMX2595 and to LMX2572 to feed LVDS differential Signal and i have few questions:
1) What is the maximum differential…
Part Number: LMK00304 Other Parts Discussed in Thread: LMK00301 Hi
We want to use LMK00304 in our design, we are working on PCIe Gen 4 complaint clocking but LMK00304 mention in its datasheet that it supports only Gen 3, but similiar series part LMK00301…
Hello Ann Lien,
I'm a little confused by your question. I think this diagram from the data sheet (p. 18) will allow us to both understand each other better. If the diagram still doesn't help you understand the waveform and the specs from the data sheet…
Part Number: ADC12QJ1600EVM Other Parts Discussed in Thread: LMK04828 , LMK00304 , I see in the user manual there are four possible options for clocking the ADC and FPGA together. I'm looking into option 1 "EXT CLK from LMK to ADC" (Default). It looks like…
Hi Asim,
Thanks for your reply.
Asim Khan said: So if there is any noise those lines that would result in burn go in differential high state because this bias difference is the only method on this part to keep the output to differential low state.
Could…
Part Number: LMK00304 Dear team,
I would like to double confirm input range spec in datasheet with you.
Based on datasheet, Vss=2*VID=1.3*2=2.6V.
But VIHD=VCC and VILD is GND, for our application(VCC=3.3V), the delta-V is 3.3V in this case.
Which one…
Part Number: LMK00304 Hi experts,
I'm using LMK00304 in my design. there are two parts in my board, both inputs are driven by two outputs of a PLL with the same frequency and same phase, the frequency is 100MHz, I want to calculate the propagation delay…
Part Number: LMK00304
Hi expert,
My ctm want to do AC coupling input for LMK00304 . I see below post saying there is internal biasing providing the input offset -0.3V. And I just want to confirm this internal biasing provides the common mode voltage…