Hi Vibhu-san,
I really appreciate for your great support. I have one additional question to your comment on 2) and 3).
Did you measure the pin voltage using the EVM ? If this is the case, this is because the EVM has external resister divider.
Can…
Hi Frantisek,
LMK03328EVM CodeLoader Software User's Guide has a description of the *.epr file format. See Figure 11: www.ti.com/.../snau185.pdf
Table 10.7 of the datasheet gives the EEPROM Map that corresponds with a LMK03328 EEPROM file. www.ti…
Part Number: LMK03328 Other Parts Discussed in Thread: , USB2ANY Hi team,
The customer uses LMK03328. When he uses his LMK03328 board (not LMK03328EVM) with USB2ANY, and TICSPRO software,there is an error.
It shows"USB communication Error ERR_I2C_ADDR_NAK…
Nir,
Sorry for the delay in response. Is this question still open?
If no, could they use a LMK03328EVM and blue-wire the SDA/SCL/GND lines from the EVM to the target device on the customer's board and program it using the TICS Pro? They can disconnect…
Hi Timothy,
Thank you for your reply.
I'd like to try your advice.
■Oscilloscope
Keysite : DSAZ204A
→ I used TIE function of oscilloscope.
See attached URL , page 9.
file:///C:/Users/090727/Downloads/AN10007-Jitter-and-measurement%20(2)…
LMK03328 will meet the clock requirements in the CLK request spec document with a 50 MHz crystal input.
- PLL1 with 5 GHz VCO could support 100 MHz outputs PCIE, MAC REFCLK) and 156.25 MHz output (ISG/SerDes REFCLK).
- PLL2 with 5.16 GHz VCO could support…
Here is a link to a small training series on using the LMK03328EVM and TICS Pro. I typically use CodeLoader rather than TICS Pro for programming.
training.ti.com/lmk03328-evm-setup-and-programming-tics-pro-gui
Is it 33MHz or 33.333 MHz (33 + 1/3…
Hi Shimizu,
R145 (REGCOMMIT_PAGE) determines which EEPROM/SRAM page is written to when running REGCOMMIT (which copies the register contents to the SRAM for EEPROM programming). There are 6 total pages (page 0 to 5).
Then, after programming the EEPROM…
Part Number: LMK03328 Other Parts Discussed in Thread: CODELOADER , , USB2ANY , TICSPRO-SW Hi team, Please allow me to ask you some questions from our customer as below,
1. We can see the description in the datasheet as below,
(P.47 - 48 in the datasheet…
