The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: LMK04100 Tool/software: Hello,
I needed to change the default values of the registers on the IC as given in the memory map, how do I change the values based on my requirement of different frequency etc? (The memory map is given in the datasheet…
Jass,
This will depend on the output jitter required. For lower-performance systems, CDCE813-Q1 will be suitable as a jitter cleaner. If better performance is needed, LMK04100 may be a better solution.
CDCE813-Q1 jitter performance (note: this is not RMS…
Part Number: LMK04100 Other Parts Discussed in Thread: LMK04208 , Hello,
Our customer wants to get better Jitter suppression performance from LMK04100 or LMK04208.
Their input clock is 44.1KHz with 80nsec jitter, output are is x512=22.579MHz and x1024=45…
Part Number: LMK04100 Other Parts Discussed in Thread: LMK04208 Hello,
Our customer look for Audio system clock PLL.
Input is Audio Word Clock which is 44.1KHz and Outputs are x512=22.579MHz and x1024=45.158MHz.
It seems LMK04100 can accept 0.001MHz input…
Part Number: LMK04133 Hello tech team,
Is it okay to leave unused clkout pins floating? Or should we terminate them with 100-ohm (and ac-coupled)?
Thanks in advance,
Kazu
Part Number: LMK04100 Other Parts Discussed in Thread: LMK04821 Dear Technical Support Team,
I couldn't find recommended termination for reference clock on LMK04100 datasheet .
LMK04821 datasheet shows following schematics .
Can I use it for LMK04100…
Danilo,
We can consult the chart used to design the USB2ANY-uWIRE to confirm the connections:
USB2ANY-uWIRE Chart.xls
I generated the simplified table below for jumper wiring:
FUNCTION
EVM pin
USB2ANY pin
Readback
1
3
CLK
2
8
DATA
4
4
LE
6
…
Other Parts Discussed in Thread: ADC10080 , LMK00804B , CDCLVC1104 , LMK03318 , LMK04100 , LMK04816 We are designing a 4-channel ADC system with ADC10080, pls do not recommend any new parts for us, we just need to use this part for cost and power consumption…
Hi Madhu
Thank you for quick reply.
Let me ask you an additional question.
My customer will use single input for LMK04100 Family , however is following diagram on LMK04186 datasheet P108 able to adapt to LMK04100 Family ?
Best regards.
Taichi
Other Parts Discussed in Thread: LMK04100 Hi,
On the LMK04100 EVAL. Does the Vtune work?
Our coustomer has got the lmk04100 and it seems that there is no voltage output for Vtune.
I have one eval board like that in my office and same result.
Could you…
