Part Number: LMK04828 Other Parts Discussed in Thread: ADC34J45 Hello,
We are working in a design where LMK04828 is connected to an ADC (ADC34J45) and we need to know which the configuration of LMK4828 outputs is (i.e. disabled or enabled) when LMK04828…
Part Number: LMK04828 Hi
I am trying to create a pulse (one pulse) at multiple SDCLK outputs.
The pulse needs to come out at a sync event which is originated at the CLKin0.
So far I've managed to do create a pulsed output only when working with the SYNC…
Jason,
Re-clocking is especially useful for when you need to SYNC your outputs with your SYSREF pulse, which in turn would be related to the input signal in ZDM. So you have more than just SYSREF signals being generated from your LMK04828 boards then yes…
Part Number: LMK04828
I want to control the SDCLKoutY pin from the SYNC pin like as through path mode.
I tried to set the registers like below and toggled SYNC pin, but I couldn't control output.
Would you tell me how to access the registers ?
-…
Andres,
I apologize for the delay. To ensure lock, you should first check your PLL divider settings to ensure lock is even possible. This can be done with our configuration software TICSPro . I have attached a tcs config file that should lock for your testing…
Part Number: LMK04828 Other Parts Discussed in Thread: ADC12DJ5200RF , , LMK04832 Hi!
I am working on configuring the ADC12DJ5200RF dev board and having some difficulties programming the LMK04828B. I am using TICS Pro to configure each register with the…
Part Number: ADS54J60EVM Other Parts Discussed in Thread: LMK04828 Hi
Another question is the setting the LMK04828. LMK_Config_Onboard_983p04_MSPS
In the configuration file, the values of the registers at the address such as 0x139, 143, 140, 144, changes…
Jason,
shen jie said: first rule of ZDM which require the GCD Between Input and Output Frequency must Equal Input Frequency
This rule is applicable only to automatically create determinism in ZDM without a SYNC necessary. But because we have a SYNC pulse…
Part Number: AFE7900EVM Other Parts Discussed in Thread: USB2ANY , LMK04828 Hi,
we want to change lmk configuration on AFE7900EVM, but ability to configure lmk via Latte iGui is very limited. Full-software conf option: Latte through configuration process…
Part Number: LMK04828 Is it okay to output DCLKoutX (both positive and negative) and SDCLKoutX (both positive and negative) at a fixed low level during reset?