The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: LMK61PD0A2 Other Parts Discussed in Thread: LMX2595 , LMX2595EVM , USB2ANY Tool/software: Hello, We are currently working with the LMX2595 Evaluation Board and using the LMK61PD0A2 as the reference clock source. However, we are encountering…
Part Number: LMK61PD0A2 Other Parts Discussed in Thread: TPS7A8300 Tool/software: Hi,
We are using LMK61PD0A2 Oscillator which is supplied 3.3V FROM TPS7A8300ARGRR IC.
We have checked voltage and current requirements of TPS7A8300ARGRR which is sufficient…
Part Number: LMK61PD0A2 Other Parts Discussed in Thread: LMK61PDEVM Is there a schematic and user guide or similar for the Reference Pro board with LMK61PD0A2 ?
I can only find that for a similar board LMK61PDEVM, similar, but not the same.
Regards
T…
Part Number: LMX2594 Other Parts Discussed in Thread: LMK61PD0A2
Hi Expert,
My customer is evaluating LMX2594EVM.
When They checked the Phase Noise of 8GHz output when the Ref Clock input to the PLL was used with the LMK61PD0A2 set to 100MHz,
The data…
Part Number: LMX2594EVM Other Parts Discussed in Thread: LMK61PD0A2 Tool/software: Hello.
We purchased LMX2594EVM.
First, we tried to check the output of Reference PRO.
Configured control pin :
- 100 MHz (FS1 :0 and FS0 : 0)
- LVPECL (OS : 0 and OE…
Part Number: LMK61PD0A2 Is there an available schematic for the reference pro board? I want to see the circuitry schematic on the LMK61PDOA2, so I can get an idea of the voltage rails on the LVPECL signals
Also, what is the estimated output power for…
Part Number: LMX2594 Other Parts Discussed in Thread: LMK61PD0A2 hi sir
LMX2594RHAT check the input spec
(1) support input frequency range?
(2) support the input range?
Can LMX2594 to accept the signal of LMK61PD0A2(100MHz,LVDS)
thanks
Part Number: LMX2594 Other Parts Discussed in Thread: LMK61PD0A2 , USB2ANY , I am using an Arty-A7 FPGA dev board to send SPI Commands into the LMX2594. When I send my commands I get no response from the device, I have verified the boards operation by programming…