The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.



Search tips
Showing 49 results View by: Thread Post Sort by

  • LMP2012: Failure Modes

    TI Thinks Resolved
    Part Number: LMP2012 I am working on a reliability study on one of our designs using the space qualified version of the LMP2012 dual opamps IC and wanted to see if I could get the FMEA of the IC. Specifically, I'm looking to see if one of the opamps fails…
    • Answered

  • Lmp2012: LMP2012 common-mode input voltage

    Resolved
    Part Number: LMP2012 Hi all, The LMP2012 datasheet states that common-mode input voltage is -0.3 to Vcc+0.3. From this information, i guess V- pin of the LMP2012 should be GND. I wonder that can i apply negative supply to V- pin of Lmp2012? Regards, …
    • Resolved
    • Answered

  • RE: LMP2012QML-SP: Common Mode Input Range (recommended max specification)

    Resolved
    LMP2012 input common-mode voltage is: (V-)-0.3V<Vcm<(V+)-1.8V

  • LMP2012: Output impedance vs frequency curve

    TI Thinks Resolved
    Part Number: LMP2012 Hi all, I didn't see any information about output impedance in LMP2012 datasheet. Please share output impedance vs signal frequency curve of this product. This information is necessary for my circuit design. Best regards, E…

  • LMP2012 Schematic Diagram

    Other Parts Discussed in Thread: LMP2012 , LM158 , LMP2012QML-SP I am looking for the Schematic Diagram of the LMP2012 for SEDR radiation analysis. I have seen the LM158 Schematic Diagram on the LM158 datasheet but I can't find the LMP2012's diagram.…

  • LMP2012 input bias current

    Other Parts Discussed in Thread: LMP2012 , LMP2022 , LMP2012QML-SP Hello, I've got a question about the input bias currents on the LMP2012 : The "5V DC Electrical Characteristics" table in the datasheet specifies a typical input current of -3pA at 25…
    • Answered

  • LMP2012QML-SP: (or commercial LMP2012) - What is the Max/Min Input bias Current?

    Resolved
    Part Number: LMP2012QML-SP Other Parts Discussed in Thread: LMP2012 , LMP2012QML , LMP2021 , LMP2011 Hello, We are developing payloads for space missions (Mars rovers for 2020) and we have some important doubts regarding part LMP2012/LMP2012QML which we need…
    • Resolved
    • Answered

  • LMP2012QML-SP: Op-amp output ripple

    Resolved
    Part Number: LMP2012QML-SP Other Parts Discussed in Thread: LMP2012 , LMP2022 Hello, we've been looking into the output ripple on our parts which use the LMP2012 op-amp. The output ripple is measured to be about 18kHz, is there any theory on why this…
    • Resolved

  • LMP2012 Thermal Resistance Value?

    I’m looking for the thermal resistance (junction-to-air) Thank you

  • LMP2012 minimum input voltage

    Other Parts Discussed in Thread: LMP2012 The LMP2012 datasheet states that the LMP2012 minimum output is 95mV (worst case). what is the minimum input voltage? If I use a non inverting amplifier configuration with a gain of 50V/V, can I apply a 2mV input…

Didn't find what you are looking for? Post a new question.