Part Number: LMP2012QML-SP Other Parts Discussed in Thread: LMP2012QML I am using LMP2012QML (5962L0620602VZA) op amp on a space flight board. The output was inadvertently shorted to ground. I'm wondering if this op amp has output current protection or…
Part Number: LMP2012QML-SP Other Parts Discussed in Thread: LMP2012QML , LMP2012 Hi.
I am using LMP2012QML in 2 opamp instrumentation amplifier configuration with the one opamp being near unit gain and pspice simulation has GM (gain margin) of 14db, same…
Part Number: LMP2012QML-SP Other Parts Discussed in Thread: ADS1278 , LMP2012 , LMP2011 , TINA-TI , THS4511 , THS4513 , THS4304 , THS4521 , LMP2012QML , ACF2101 , IVC102 Hi,
What is output impedance and maximum capacitive load driving capability of the op amp LMP2012QML…
Part Number: LMP2012QML-SP Hi, what are common-mode input voltage range and maximum output voltage swing (1k and 10k loads) specifications for the op amp LMP2012QML-SP with V+ = +2.5V and V- = -2.5V operating power supplies?
Thanks
Dinakar
Part Number: LMP2012QML-SP Hi,
What is the maximum input bias current of the op amp at its chopper frequency? I want to use the part for photo-diode I to V conversion with 14-bit accuracy and 2 kHz signal rate.
Thanks
Dinakar
Part Number: LMP2012QML-SP Other Parts Discussed in Thread: TINA-TI Hi Experts
1) When will the LMP2012QML-SP model be available in PSpice for TI. It is not currently showing up in the search there.
2) Are there any known issues using the existing PSpice…
Hi Mike.
Thank you very much for your answer.
I have searched the Amplifiers forum with your key words "common mode" instead of my "rail-to-rail", and found this issue has been discussed 5 years ago.
TINA/Spice/LMP2012QML-SP: Input…
Part Number: LMP2012QML-SP Hi all. I am working on a design that disallows any floating copper.
I am using the LMP2012QML-SP (5962L0620601VZA) which has two N/C pins (pins 5 and 6). Can I tie these to ground?
Thanks,
Eric
Part Number: LMP2012QML-SP Other Parts Discussed in Thread: LMP2012 , , MKT-WG10A-MS Interested to buy engineering model - which P/N is a valid one ? and for FLight model - which P/N to use ?