Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: LMP7702 Other Parts Discussed in Thread: OPA391 , OPA392 , OPA396 , OPA376 Tool/software: I am looking for to operate from 0V input till close to Vdd. Actually I am using LMP7702 for baffa. But at the very low input voltage suvh as a few mv…
Part Number: LMP7702 Other Parts Discussed in Thread: LMP7721 , , TINA-TI
Hello guys,
One of my customers wants to run a circuit simulation of a transimpedance amplifier circuit for a photodiode with LMP7702 or LMP7721 using TI simulator, TINA-TI or PSPICE…
Part Number: LMP7702 Other Parts Discussed in Thread: PCM1803A Hi
We design a circuit for the audio transmitting, We test the input nosie of LMP7702(Pin 2 and Pin 3) is 115dbu, and the output is 108dbu, Do you have any suggestion to improve the output…
Hi Marvin,
This is nearly identical to this thread:
https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1183343/lmp7702-output-impedance/4471169#4471169
Please refer the customer (is it the same one?) to the post above and let us…
Other Parts Discussed in Thread: LMP7702 Dear Comminity,
I have a probelm with one of my 2 opamp inside the LMP7702. The opamp is super-sensitive to temperature: when below 40 deg everithing is fine but when the temperature gose over 40 deg, I found the…
Morning Patrick, well -
1. The TL082 is a dual, assume you would like to continue with that
2. Your ADC is probably 0V ot 5V supply so your +/-5 op amp supply is ok if your input does not force below ground and will support a true swing to gnd operat…
Other Parts Discussed in Thread: RC4580 , OPA1678 , OPA2333-HT , LMC662 , LMP7702 Hi
Want to know if there is a chip available to filter 50 Hz line frequency noise.
Tried fliege notch filter using LMC 662 opamp but, was unable to effectively filter the noise…
Part Number: LMP7701 Other Parts Discussed in Thread: LMP7702 Hi, I have half of an LMP7702 configured as a unity-gain buffer amp. When the input signal gets to about -1.5 V, the output clips. An LMP7701 in the same circuit has a 20-kohm feedback resistor…
