Part Number: LMR14030-Q1 Other Parts Discussed in Thread: LMR14030 , LM5149 I would like to use LMR14030SQDPRTQ1 for making +12V, 2A power supply.
I have one requirement in the circuit that if 12V input is given to IC, the output should be 12V. Is this…
Part Number: LMR14030-Q1 Hi team,
Is there any concern if I use 0.22uF as Cboot of LMR14030-Q1 while 0.1uF is recommended?
Could you please advise the maximum value I could use for Cboot?
regards,
Part Number: LMR14030-Q1 Other Parts Discussed in Thread: LM63635-Q1 , LMR14030 Hi, Can you confirm whether LMR14030-Q1 is equivalent to ASL B rated IC. If not, could you please explain why not? Could you recommend and ASIL rated IC with the same/EMI per…
Part Number: LMR14030 Hi team,
Would you please help comment on the difference design margin between these two circuits?
Below 1st figure had some abnormal working conditions compared with 2nd figure. Both of the parameters are the same except for adding…
Part Number: LMR14030-Q1 Am I correct in thinking that when Webench reports a negative gain margin, it actually means the gain is negative at the phase crossover and therefore (GM (dB) = 0 - G(dB) @ phase crossover) the system has a positive gain margin…
Part Number: LMR14030-Q1 Hi Team,
We know from DS that IQ=40uA(typ) when Tj=25C.
Customer consulted us when Tj=85C, roughly, what value will IQ become?
Kindly help to advise. Thanks.
Best regards,
Terry
Part Number: LMR14030 Hello Team,
I am going through Application report SLUA844B.
I have few queries, on the topic "thermal characterization parameter" discussed. I wanted to raise a question on this Report, but the forum is asking for a part number, So…
Hi Gerald,
We haven't heard from you in while so I am going to resolve this thread. If you have any more questions, please feel free to reply here again to reopen the thread.
Best regards,
Ridge Lahti
Part Number: LMR14030 Hi Team,
My customer got an issue using two LMR14030 with Sync pin in parallel.
It's look like that one of the device is instable.
They used the draft from the datasheet FIG 17 left schematic not knowing if their input clcok…