Part Number: LMV321 Tool/software: We have identified an issue with the LMV321IDBVR ICs where units with different countries of origin (COO) exhibit variations in wire bonding and lead frame patterns.
This discrepancy has led to functional test failures…
Part Number: LMV321 Other Parts Discussed in Thread: OPA310 Tool/software: The LMD321IDCKR operational amplifier is used in the voltage follower circuit. If 4.2 V is input and 40 mA flows to the output, the output will be 1.5~2.5 V. The voltage waveform…
Part Number: LMV321 Other Parts Discussed in Thread: LM321LV , TLV9001 I would like to use a small single opamp as a buffer monitoring battery input for a signal, the power is supplied by uC output pin, so is 3.3V, the device will be powered off most…
Part Number: LMV321 Other Parts Discussed in Thread: TLV9001 Tool/software: Hi
We found two kinds of internal wafer marking for this product. Could you please help confirm the reason thank you
Part Number: LMV321 Hi
Because there are some different MSL information of LMV321IDCKR between datasheet & website.
Can you help me clarify the MSL information for LMV321IDCKR, thanks.
Part Number: LMV321 Other Parts Discussed in Thread: LM321LV , TLV6002 , TLV9151 , TLV9001 Hi,
Customer looks for replacement for ST LMV321. His concercern is p2p(SOT23-5) and offset.
The offset of ST/LMV321 is 0.1mV(TYP). TI LM321LV is 1mV, and…
Part Number: LMV321-N Other Parts Discussed in Thread: TLV9001 Hello:
LMV321M5X/NOPB is used on the customer's motor motherboard, the main purpose is to monitor the temperature through the output voltage of the chip. During the test, there were several…
Part Number: LMV321 Hi
We need to collect 0 to 5 volts from the external input. The test shows that when the input voltage is 0 volts, the voltage at the front end of the op amp is 0 volts, but the voltage at the back end of the op amp is about 0.05…
Part Number: LMV321
Some application, we would do duty OPA (LMV321) power-on/off always from +3.3V to V+ / GND to V- like above picture “green”, during 100us OPA power enable and 218us power disable with ~3.1KHz.
Does it have any concern and OPA reliability…
Part Number: LMV321 Other Parts Discussed in Thread: LM321 ,
I have a basic op amp circuit diagram consisting of LMV321 and LM321 as shown below. The reference voltage for both OP Amp ICs are 2.5V. The input voltage is 5V. I want to re-design the circuit…
