Search tips
Showing 24 results View by: Thread Post Sort by

  • LMV841-Q1: LMV841QMG

    Part Number: LMV841-Q1 Dear expert, We will be using the LMV841-Q1 IC for our project but we need below parameters: Failure Mode Distribution Pin FMEA Can you provide parameters above? Your help would be appreciated. Best regards, tatsuya…
    • Answered

  • LMV841-Q1: Failure Mode Distribution & Pin FMEA

    Resolved
    Part Number: LMV841-Q1 Other Parts Discussed in Thread: OPA388-Q1 , LMV842-Q1 , Dear expert, We will be using the "LMV842QMA/NOPB","LMV841QMG/NOPB" IC for our project but we need below parameters: Failure Mode Distribution Pin FMEA Can you provide…
    • Resolved

  • LMV841: parasitic capacitance on supply PIN's V+ and V-

    Part Number: LMV841 Hi, do we have any information on the size of the parasitic caps @ V+ and V- ? I think it might be even better if we have any kind of load characterisitcs like on the parasitic L and C for these PIN's. Looking forward to your…
    • Answered

  • RE: LMV841: Capacitive load and "RISO"

    Resolved
    Hi David, different capacitive loads affect the phase response at different frequencies. With a load of 100n you have two "construction sites", one at about 100kHz and another at the unity gain frequency due to the internal protection resistors. Then…

  • LMV841: Phase margin difference between rev.I and Rev.H

    TI Thinks Resolved
    Part Number: LMV841 Hello, The LMV84x datasheet was revised at Oct/2017. I have the question about this revision change. (1) Phase Marin and Overshoot In the EC table , the phase margin is not difference between Revision I and Revision H.Both specifications…

  • LMV841 / about Absolute Maximum Ratings

    Other Parts Discussed in Thread: LMV841 Hi, I consider LMV841 circuit. Regarding Absolute Maximum Ratings, should LMV841 restrict both VIN differential(±300mV) and Input current(10mA) ? or, all we have only to obey either VIN differential or Input current…

  • RE: LMV841 untity gain driving capacitive load with out-of-loop compensation

    Hi Eduardo, 10K is more than enough...Usually only a few hundred ohms is needed. You should be fine. Regards,
    • Answered

  • Temperature extremes in LMV841

    Resolved
    Other Parts Discussed in Thread: LMV841 Hi! In the data sheet for the LMV841, it states that the boldface limits applies to temperature extremes. Can the assumption be made that this applies in fact to the temperature range 85-125C, or what is temperature…
    • Resolved

  • LMC6762: Input current vs. Input Voltage

    TI Thinks Resolved
    Part Number: LMC6762 Other Parts Discussed in Thread: LM339 , , LMV841 Hello Team, Customer is asking if there is a negative input voltage vs. Input current curve as attached shown. and is there similar application node available? LM339 is a Bipolar…

  • OPA991: too high distortion of the 60kHz amplifier

    TI Thinks Resolved
    Part Number: OPA991 Other Parts Discussed in Thread: TLV9161-Q1 , OPA172 , TLV172 , LMV641 , LMV841 , OPA992 , OPA2991 , TLV9361 , OPA2992 Hi, We're designing a product with analog amplifier. Signal: AC sinus 60kHz, gain of 3.2, power voltages +-4V…

Didn't find what you are looking for? Post a new question.