Part Number: LMV951 Tool/software: Hi Expert,
Customer would like to design a constant-current source circuit with 1V / 10A.
For OPA, Does LMV951 can support 1V input voltage?
If there is any better device, please also suggest. Thanks.
Part Number: LMV951 Other Parts Discussed in Thread: TINA-TI I'm trying to create a Bandpass filter in the https://webench.ti.com/filter-design-tool/ but there's no data for the LMV951. What are my choices?
Part Number: LMV951 Other Parts Discussed in Thread: TLV316 , Hello support team,
My customer would like to use LMV951 as charge amp and achieve same gain/phase performance with Vcc 1.3V as TLV316. However, the performance looks different from TLV316…
Hi Dave,
You cannot leave the shutdown pin floating. There is not a pull-up/pull-down resistor inside the LMV951 to enable/disable the device if the shutdown pin is left floating.
The gain setting resistors should be large enough such that you do…
Part Number: OPA2365 Other Parts Discussed in Thread: LMV951 I am using OPA2365 to configure the voltage follower circuit below.
As I raised the V+ voltage, -IN_B stuck to V+ around 1.1V to 1.5V.
I would like to know why it behaves like this…
Hi Chuchen,
Realistically a 0.4% deviation below 1.8V (1.7928V) is likely not going to cause any issues. However, the customer will have to evaluate the performance of the device on their own and make their own design decision that performance meets…
Hi Lucas,
Lucas Hölbling said: Is a load resistor to GND on the output required?
This technique is discussed in the datasheet of OPA364. See figure 24.
In the datasheet of OPA320 the use of a Schottky diode to generate a negative supply voltage…
to User473,
I searched all the op amp portfolio with the parametric search (precision, general purpose, and high-speed). There are 6 options with temperatures of 150C and above (see attached). The best match is the OPA211-HT (210C max). This is the…
