Part Number: LMX2594EVM Other Parts Discussed in Thread: LMX2594 , LMX2572 Hii all,
I am new in using the LMX2594 EVM board. I want to generate a frequency sweep from 4.5 GHz to 4.8 GHz with minimum sweep time. Can you help me from where i can get the…
Part Number: LMX2594EVM Hello Support team,
I read the datasheet, and I found in 7.3.11 Phase Adjust.
It says When MASH_SEED and Phase SYNC are used together with IncludedDivide > 1, additional constraints may be necessary to produce a monotonic relationship…
Part Number: LMX2594EVM Hello Support team
I read the datasheet, and I found input signal needs to be square wave because it has requirement of duty cycle and rising/falling edge.
But in datasheet 8.1.1 OSCin Configuration, I found there is sin wave.
…
Part Number: LMX2594EVM Hi Experts,
Good day.
For the LMX2594EVM, is it possible to achieve ramps faster than 1us? Can you guide us how
Thank you.
Regards, Archie A.
Part Number: LMX2594EVM Dear，
One customer used LMX 2594EVM for frequency sweep, the bandwidth is 200Mhz, sweep range is 7.6G ~7.8Ghz, but there are many spurs less then 7.6Ghz and more than 7.8GHz. What is the reason?
The last image is the frequency…
Part Number: LMX2594EVM Other Parts Discussed in Thread: LMX2594 , LMK04832 Hi:
again, We design the new board and have another spur, shown below, which we found about 200Hz away from our Lo, and set register.
R112 0x700000 R111 0x6F0000 R110 0x6E0000 R109…
Part Number: LMX2594EVM Other Parts Discussed in Thread: MSP430FR5969 Hi,
I'm trying to configure the LMX2594EV's registers by SPI communication.
my master device is MSP430FR5969.
I don't see the SDI and SCK signals when ן check the TP on the LMX2594EV…
Hi Michael,
I think your EVM might be faulty, maybe you should ask for a replacement.
Please contact the customer support center for warranty information
Customer support center – Homepage - Customer Support (service-now.com)
Part Number: LMX2594EVM Other Parts Discussed in Thread: LMX2594 Hello,
1. For LMX2594 EVM board Schematic, R32 =100 Ohm register is DNP, where for LMX2615 EVM board schematic, R32=100 connected. if i have to use one input RF pin in place of two then…
Part Number: LMX2594EVM Hello,
I need a Letter of Volatility for LMX2594EVM. I can provide a questionnaire template if a letter is not already available.
Thank you,
Natalie
