Part Number: LMX2615-SP Tool/software: Hello
LMX2615 can have single-ended CMOS and Sinewave or differential wave for the input clock.
Is it possible to use a differential squared wave for the input clock?
In addition, can the wave type of the output…
Part Number: LMX2615-SP Tool/software: Hi, this part has a register that can control the drive strength of the RF outputs. Is there a way to adjust this drive strength in the IBIS model?
Part Number: LMX2615-SP Other Parts Discussed in Thread: LMX2594 Tool/software: Hi,
We are looking to apply an LVPECL clock to the Oscin of the LMX2615-SP. This clock is 10 MHz and produces a 1Vpp-diff (500mV-single-ended) swing. The Electrical Characteristics…
Part Number: LMX2615-SP Dear Team,
My customers is planning to work with the LMX2615-SP on a new project.
On the LMX2615-SP datasheets (attached) there are 2 places with recommendations\restrictions about the bypass capacitors and they are not the…
Part Number: LMX2615-SP Tool/software: I'm looking in using the RFOUTA/B as an LVDS clock between 150MHz - 350MHz as an input to FPGA pins.
Looking at the datasheet and trying it out on the Eval board, the output differential levels is too high for…
Part Number: LMX2615-SP Hello - I am currently looking to use LMX2615-SP in a program that requires a clean synthesizer output with no sideband modulation for use in a scientific measurement. Normally, one would be able to estimate sideband contamination…
Part Number: LMX2615-SP We are using the 5962R1723601VXC (LMX2615-SP) in our design were looking for assembly guidelines.
We assume the part should be lead formed, but it also has a heat sink pad which needs to be thermally and (maybe) electrically…
Part Number: LMX2615-SP Tool/software: On RFOut it is recommended to place a 50 ohm pull up resistor to Vcc. Our Vcc is 3.3V.
We need to determine what voltage drop we can expect across this 50 ohm resistor in order to meet our power derating requirements…
