Part Number: LMX2820EVM Hi,
So I am wanting to verify the locking speed of this particular part when changing from one frequency to another frequency. In my case I am adjusting the output of the synthesizer from 15.5GHz to 16.6GHz. I have the frequency…
Part Number: LMX2820EVM Other Parts Discussed in Thread: LMX2820 hi noel
I found a new problem, and I want to help verify it. It appears when I operate on the evm.
step1 :Initialize as attached file,write all reg;
step2:click the"FCAL_en", FCAL_EN =0;…
Part Number: LMX2820EVM Other Parts Discussed in Thread: LMX2594 , LMX2820
Hi, I can't find any information about real programming sequence (of registers) for the device. Can you help me? Thanks
Part Number: LMX2820EVM Other Parts Discussed in Thread: TICSPRO-SW Hello,
I would like to use python to automate testing of the LMS2820EVM board. I am using a win 64 bit system.
At first, I made sure I was able to connect to the device using the TICS…
I try that a master using SPI interface to communicate with LMX2820EVM.
Write operation is correct, but read operation is incorrect, so I don't think that ground too long to cause the MUXOUT signal issue.
Part Number: LMX2820EVM Other Parts Discussed in Thread: LMX2820 Dear Sir or Madam,
I'm evaluating LMX2820 EVM.
When I use the EVM with the following codition, the output signal is clear. output; 6GHz Reference clock; 100MHz PFD; 200MHz
But when I use…
Part Number: LMX2820EVM Other Parts Discussed in Thread: LMX2820 Hi All, Currently working through implementing an active filter on the LMX2820 evaluation board. Simple question, what does this note mean? ["Set Pin 3 voltage to 1.3V"] We added in the filter…
Part Number: LMX2820EVM Hi
Are the noise peaks I am noticing due to the on-board regulators feeding the VCO?
I do have a wide bandwidth (~160kHz)
Changing the loop bw (narrower) did not seem to have any affect their level above the floor - not able to…
Part Number: LMX2820 HI
I'm using the LMX2820EVM in a feedback with 2 mixers configuration.
The RF output frequency from LMX is 4.3GHz and there is mixer with 4GHz LO to down convert 300MHz IF. (There is a low pass filter on the output of the mixer…