Part Number: LP-AM243 Tool/software: We would like to find ways to optimize the ability of the AM2432X to send udp messages, with the goal of consistently sending udp messages at 400Mbps while maintaining a Cpu load of 70%. Currently, we have tested that…
Part Number: LP-AM243 Tool/software: To whom it may concern
Yesterday, I was testing and debugging normally for GPIO, connecting the 3V3 pin with one of the GPIO pin. Then when I tried to repeat the experiment today, CCS put out (CS_DAP_0: Error connecting…
P Zy said: What I'm testing is the chip's performance in forwarding udp messages from network port 1 to network port 2
This is layer-2 switching performance. correct??
Have you done some application code modification or running out of box example…
Part Number: LP-AM243 Tool/software: Hi,
・Receive a null packet or a 1-byte packet at any EP. (Transfer Descriptor is not set.) ・Write the EP number corresponding to EP_SET. ・Write DFLUSH to the EP_CMD register (wait until DFLUSH becomes 0). ・BUFFEMPTY…
Hello Sabari Kannan Muthalagu ,
Sabari Kannan Muthalagu said: Is that ok?
Yes, that's fine and no issues. But in was 9.1 version I, have never given that command. I assume that when we work on MCU+SDK that command is not required.
Sabari Kannan…
Part Number: LP-AM243 Other Parts Discussed in Thread: UNIFLASH Tool/software: Hello all,
From our understanding the M4F does not have any access to the OSPI for XiP execution, can you confirm if there isn't any way to XiP on the M4F?
Thank you and…
Hello,
Yukinobu Hasinoguti said: When I run the UART Uniflash command, is the device converted to HS-SE?
No, it will only flash the tiboot3.bin to OSPI. You would need to switch the bootmode to OSPI to allow ROM to boot tiboot3.bin.
Yukinobu Hasinoguti…
Part Number: LP-AM243 Hello to the development team. I am developing software for an EtherCAT subdevice using your LP-AM243 board. I am using the Industrial Communications SDK ind_comms_sdk_am243x_2025_00_00_08 and the MCU+SDK mcu_plus_sdk_am243x_11_01_00_19…
Part Number: BP-CC3301 Other Parts Discussed in Thread: LP-AM243 , CC3301 Hello E2E Experts,
Good day.
I realized I had misunderstood something, so please allow me to ask again. I would like to measure the Wi-Fi latency from the start of CCA to ACK…
