Part Number: LT1014-MIL Hello
I have several questions for device
When the upper OP-AMP is a normal Vcc input and the lower OP-Amp is an abonormal Vcc input, the voltages at points 1 and 2 are not equal. Can leakage occur at the input of OP-AMP when the…
Part Number: LT1014 Other Parts Discussed in Thread: OPA196 There is an argument in the circuit applied to the LT1014 chip, so please inquire as below, and please refer to thr attached picture file.
It is necessary to check whether the value of Vom (Maximum…
Part Number: LT1014 Hi Sir,
A customer has a inquire about stability when LT1014 is used as attenuator.
The application note warns that using op amps as attenuators can cause instability when tageting high frequency applications in tens of MHz range…
Part Number: LT1014 Hi Team,
One of my customer is using LT1014 and need confirmation on the max and min input which can feed to the device while operating at 5V Vcc. Is it possible to give -13V input to LT1014 powered from +5V Single supply. No ESD diodes…
Part Number: LT1014 Hi High Reliability team.
Can we get information which is protection reverse voltage on LT1104 as a below?
Best Regards
Gerald choi
Part Number: LT1014-MIL Other Parts Discussed in Thread: LT1014 , LM124AQML 5962-89677022A (LT104)
Question1) Part Number 5962-89677022A (LT104) Related Questions
What happens on the part when + 15V DC is input to VCC (+) and GND is input to VCC (-…
Other Parts Discussed in Thread: LT1014 we are using LT1014 op-amp as inverting amplifier. using single power supply (+5V) VCC- terminal connected to GND
R1(input resistance)=19.21K and RF =3K
whiling testing observed
LT1014 op-amp inverting amplifier…
Other Parts Discussed in Thread: LT1014 I am using LT1014 IC in a closed loop servo electronics to drive a load of maximum 8mA current. When I am testing this interface at low temperature especially below -15 deg Celsius, this interface output is showing…
