This sounds like a fairly serious design flaw -- and it looks like it could affect the entire LM4F line and every MCU available -- all two plus the LaunchPad. Does this also apply to the LM4F232 --specifically the kit?
It's of interest to me because…
Greetings Kobi,
"Are you using the application bootloader?" I am novice to this cc3200 ic but what I know till now is that there will be one primary bootloader in CC3200 which I can't change. For OTA primary bootloader will load /sys/mcuimg.bin which…
Hi
Please refer the quick guide.
if pmbus command is the only way, you have to change the on/off-config to OPERATION mode
and issue operation command to turn on and off.
5148.UCD90xxx Quick Guide.pptx
Regards
Yihe
Hi Board designers
Information related to RGMII interface:
Signal Naming conventions:
For the RGMII signals we are using TDn and RDn as signal names and for RMII we are using TXn and RXn as signal names.
Wanted to get your thoughts on the naming…
Other Parts Discussed in Thread: CC3100 , CC3100BOOST Namaste To All...
I have CC3100BOOST and CC3100 wifi chip(mounted in custom pcb). And a problem is SOMETIMES(5 out of 10 try) CC3100 wifi chip(mounted in custom pcb) cant connect with my internet…
Hi Tyler,
I will provide comments about the CC256x regarding your questions above. We have looped in our LMX part expert to comment as well.
- Since you are trying to send eeprom data over Bluetooth, you can easily achieve this using the bluetooth…
Hi Kas,
The air logs only show TCP connection and TCP close sequence. Nothing much there.
May I know what version of SDK you are using? Also please let me know about the Service Pack version. They should match. Looks like there is either corruption…
Hi,
This could have something to do with the interrupt handling at the host MCU. We have not such a behavior with wlan_set_ioctl_connection_policy API. Waiting in hci_evt_handler suggests that the IRQ was not detected by the host.
Also, please check…
Hi Mike,
Apologies for the delayed response.
You can download the Wi-Fi starter app at http://www.ti.com/tool/wifistarter
To use the smartconfig process the smartphone should be connected to the AP. In the smartconfig mode the device wait for…
Hi Dan,
"Setting up OTA Application for MSP430F5529LP with CC3100 SDK"
This section describes the steps to bring up and run the CC3100 OTA sample application on MSP430F5529 + CC3100.
As I mentioned earlier CC3100 OTA supports updating the service…
