Hello LLouis,
When you say "a clock configuration demo project", that means that you need an example to change MCLK, HSMCLK and SMCLK?? If that is the case you will need to enable the "custom performance levels". By default the Power Diver supports…
Yes the ipc_test test utility is supported on PSDK QNX 7.2 as well as PSDK QNX 7.3.
Note: For MCU1_0/1 to function as part of this IPC test, code modifications are required. TI is working on instructions on how this can be achieved.
For build and…
Part Number: WILINK8-WIFI-NLCP Tool/software: Linux I am playing with a customized WL1873 board plus BBB running TI processor SDK. With a customized device tree, wlan0 is correctly listed after booting of Linux and issuing "ifconfig" command. It's all…
Hi Gokul,
1. Following the Vision Apps User Guide alone leads to compilation failures during the make sdk build in ${PSDKR_PATH}/sdk_builder . The build issues were resolved only after executing the below mentioned steps in addition to Download & Install…
Hello Abid Hussain,
The error may be due to dip switch settings. Please refer to the attached guide on how to setup the EVM and connect to CCS.
OMAP-L137 EVM Hardware Setup.pdf
Regards,
Jianzhong
CONTENT
The partial return means that “UART_read to return partial data if data reception is inactive for a given 32-bit period” , as shown in picture 1 . The related file is UARTCC26XX.h .
picture 1
For a further description of partial return…
Hello Vishnu,
I asked around, there shouldnt be a need for special calibration as the device does internal calibration. We dont have a command to set an offset, however, I did find this production line testing guide that could be of use.
0624.CC256x…
Hello again!
Today I finally attempted to tackle this issue, with mixed success. For reference, I'm not using the latest SDK, my simplelink folder is called 'ble_cc26xx_2_01_01_44627'. I'm planning on switching to the CC2640R2F, but that may only happen…
