Part Number: MSP430F47126 Hi,
My customers are designing an application using MSP430F47126. Vref uses a low-noise power supply because it affects the accuracy of the ADC. However they want to use cheap power supply for DVCC and AVCC.
Does the accuracy…
Hi everybody
I'm using the Capture register of TimerA1 TACCR1 in order to measure the 32768Hz quartz error at room temperature.
Basically I supply a 1Hzsignal with 1ppm error and after a certain numer of seconds i calculate the difference on the…
Other Parts Discussed in Thread: MSP430F4794 , MSP430F47126 , MSP430FG6425 hello team,
my customer is almost finishing his design, but at this moment they notice that they don't have enough RAM memory, they need At lest 4K, is there a drop in replacement…
An additional related question :
* The datasheet specifies analog input range to be +/-Vref. Is this input range with respect to ground or in terms of (IN+ - IN -), i.e, if I were to use an MSP430 such as the MSP430F47126 powered by 0,3.3V, could I connect…
Thanks for the replies.
The SD16_A does have switched capacitor inputs per the datasheet. Admittedly it's not especially easy to find in the datasheet, but it's there. I searched for it specifically.
S-D ADCs are different from SAR, of course, but…
So I just found something interesting! I have a PC with a clean install of win10, and I installed CCS 11.2 with the command line "--mode unattended --disable-components PF_MSP430,PF_MSP432"
And then installed the arm compiler and tried to use…
Aravind, The two microcontroller products that are included in the launchpad are these: * MSP430G2211IN14 – 2kB Flash, 128B RAM, 10 GPIO, 1x 16-bit timer, WDT, BOR, Comparator A+ * MSP430G2231IN14 – 2kB Flash, 128B RAM, 10 GPIO, 1x 16-bit timer,…
As one more update, you can find the full revision table of compatible hardware and software revisions included in the release notes:
Release-Notes-MSP-GANG.htm
See the section called "Version Matrix"
Hi SeaFesse, If you check the release notes from version 1.2.8.0, in the Version Matrix section, you'll see that the MSP-GANG HW v1.04 is only compatible with version 1.2.1.0 and higher. So this combination should not be used - please use the latest…