The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: OPA171-Q1 Hi team,
Could you please help verify the single rail Vsupply min voltage of OPA171-Q1?
In datasheet first page:
In recommended operating condition
In figure
Could you please help confirm if OPA171-Q1 single supply voltage can…
Part Number: OPA171 Hello Support team,
I closed post on public and create new post in internal one.
https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1062841/opa171-vo-variation-data/3936263#3936263
Could you support the following…
Part Number: OPA4171-Q1 Other Parts Discussed in Thread: OPA171 Tool/software: Hi team,
Could you share the input to output propagation delay time with me for OPA4171-Q1?
Thanks!
Ethan Wen
Part Number: OPA171 Other Parts Discussed in Thread: TINA-TI Hello,
during simulating open-loop characteristics the OPA171 in simple inverting configuration I found different results when using TINA-TI and LTSpice. After some investigation I found potential…
There are not a lot of DRL alternatives; just two, OPA170 and OPA171.
OPA171AIDRLR is missing the shutdown pin. It also has a minimum supply of 2.7V and the upper VCM range is not supported well. It's deals with higher input voltage better than TLV341…
Part Number: OPA172 Other Parts Discussed in Thread: OPA171 Tool/software:
Hello,
So, the problem we're having is that we are seeing an increase in phase noise in our ovenized oscillator running at close to 100 Celsius. Because of that we're trying…
Part Number: OPA171 Hi team,
Here is a confusing item of Amplifier temperature drift.
From below training slide page 7, there is a Vos temperature drift Bipolar and CMOS comparison.
https://training.ti.com/sites/default/files/docs/Op%20Amp%20Tech%20Overview_0…
Part Number: THS4082 Other Parts Discussed in Thread: OPA171 Tool/software: Hi Team,
i am working on a problem , and i need your help to identify the approach.
1) info;- we are working on peak detector circuit as shown below, so here we are trying…
Part Number: OPA171-Q1 Other Parts Discussed in Thread: OPA171 Hello All,
I would like to understand that how unstability or oscillations at the output of OPAMP causes heating of device?
BR,
Nachiket W.