Search tips
Showing 30 results View by: Thread Post Sort by
    Answered

  • OPA180: about its voltage output swing from rail

    Resolved
    Part Number: OPA180 Other Parts Discussed in Thread: OPA333 , TLV333 , OPA376 Tool/software: Hi Support team, I am using OPA180 as a follower in my design. Its voltage output swing from rail of my testing is different from datasheet. When Vs = 4.5V, input…
    • Resolved

  • OPA180: cap across NC pins

    TI Thinks Resolved
    Part Number: OPA180 I would like to add OPA180 as a second source for LTC2057IMS8. I do not use the shut down functionality of the LTC2057 in my design, and I have a 0.1uF cap across pin 1 and 8. Pin 1 and 8 on the OPA180 are NC. Is it ok to leave this…

  • OPA180: Output inconsistent across multiple board

    Part Number: OPA180 Hello TI, I am using OPA180IDBVR in one of our design which is used as a differential mode to single ended amplifier with gain of 10. The issue is on physical measurement we are getting different values for the same input across different…

  • OPA180: input bias current spec

    TI Thinks Resolved
    Part Number: OPA180 Hi I am not sure how to read and use the min and max of the input bias current, I can see for the typical curves how the bias current trends. min is given as 18nA and max +-6nA. Can you explain how you would design with these specs…
    • Answered

  • OPA180: recommended operating condition

    Resolved
    Part Number: OPA180 Hi Experts, I want to confirm a recommended operating conditions. The datasheet stated that supply voltage is +/-2.25V(min). But spec is specified by +/-2V(min). I suppose recommended operating condition is typo. Would you please clarify…
    • Resolved
    • Answered

  • OPA180: Is the input offset voltage really only positiv?

    Resolved
    Part Number: OPA180 Hello everybody, in the datasheet of the OPA180 is the Input Offset Voltage only positiv. Typicall 15 uV and Max 75 uV. You can find it in 7.7 Electrical Charecteristic Is there a mistake in the datsheet? I would expect that the input…
    • Resolved

  • OPA180: Please provide typical plot for input bias current vs. common mode voltage

    TI Thinks Resolved
    Part Number: OPA180 Please provide typical plot for input bias current vs. common mode voltage for opa180. Thx!
    • Answered

  • OPA180: OPA180 Chopping Frequency

    Resolved
    Part Number: OPA180 Other Parts Discussed in Thread: OPA188 Dear Sir, Our custoemer would like to know about chopping frequency of OPA180. According to the OPA188 datasheet, there is a figure about off-set correction frequency, 3us, on page 16. I think…
    • Resolved

  • TINA/Spice/OPA180: Simulation model showing following Error : Overflow, converge

    TI Thinks Resolved
    Part Number: OPA180 Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models OPA180 simulation model showing "Overflow, converge" while Pspice simulation. Request support.

  • OPA180 and OPA2188 Simulation models

    TI Thinks Resolved
    Other Parts Discussed in Thread: OPA180 , OPA2188 , OPA2180 , TINA-TI Does anyone know if the OPA180 (or dual version OPA2180) is the same silicon as the OPA2188? If it is, I have noticed a marked difference in these two parts during noise simulation. The…

Didn't find what you are looking for? Post a new question.