Part Number: OPA202 Other Parts Discussed in Thread: OPA205 , OPA145 Dear Team,
My customer is considering to use the OPA202, and is looking at the data sheet of the OPA202. They would like to ask you the following questions about the OPA202.
Q1;…
Part Number: OPA202 Hello Team, I am new to analog circuits I have been reading the datasheet of the OP-AMP OPA202. I believe every signal should have a referance. But I don't see any reference to the input or output signals of the OPAMP. Also, If I am…
Part Number: OPA202 Other Parts Discussed in Thread: TPS22810 , TMUX6219 Hello Team, We are planning to use the opamp OPA202 in one of our designs. The Opamp is used as a buffer. A 0-10V from an analog signal source will be scaled down to 0-5V (The input…
Part Number: OPA202 The Circuit below is derived directly from the OPAx202 SPICE model download and running in PSPICE. The issue is extremely strange, and other TI Opamp SPICE Models do not exhibit this behavior. In fact I have never seen this kind of…
Part Number: OPA202 Hello Team, This post is a continuation of one of my previous post link . We need to include short circuit protection for the 0 to 10V analog output for a load less than 500E resistor. We have selected a PTC resettable fuse for this…
Part Number: OPA202 Other Parts Discussed in Thread: OPA2202
Hi team,
Background:
This is Divyanshu, applications for ORing controllers. We are building an application circuit to increase the operating voltage of one of our ORing controllers using…
Hi Oliver,
Maybe the OPA202 datasheet Electrical Characteristics Table 7.5 Input Capacitance section isn't quite clear in what information it provides. It is labelled Input Capacitance, but in reality it provides both the input resistances and input…
Part Number: OPA202
The Data sheet shows the SOT-23 5pin package to be available but the TI product page does not provide an orderable PN for the SOT-23.
Are these (SOT-23 and SC-70) supposed to be package options for the OPA202 or is this a misprint…
Part Number: OPAMP-NOISECALC Other Parts Discussed in Thread: OPA192 , OPA202 When using the OPA192 spice model in Altium Designer simulation an "unable to solve operating point" error occurs. Replacing OPA192 with OPA202 works perfectly. Any suggestions…
Part Number: OPA205 Other Parts Discussed in Thread: OPA206 , OPA202 , OPA317 , OPA330 , OPA130 In the datasheet, Figure 6-22 shows the noise density goes up after 10kHz. I've seen numerous datasheets show a flat noise at high end. And wonder what make…
