Part Number: OPA211-EP Other Parts Discussed in Thread: TLV2548-EP , Hi Team,
I have question about how to select a buffer amplifier for TLV2548-EP. I used Analog engineer's Calculator and input some spec of the TLV2548-EP.
Could you check my filling…
Part Number: OPA211 Hi Support
I am currently going through the online video training series TI Precision Labs - Opamps
In the video for offset and bias current, some calculations are done for typical & Maximum cases for OPA211 with input resistance…
Part Number: OPA211 Hi,
I am trying to get the OPA211MDGKTEP amp to work as a unity gain buffer with the Shutdown signal as an enable. The application is pretty simple, I run my signal (1kHz 1Vpp 1.5V offset sine wave) into the + of the op amp with…
Part Number: OPA211 Other Parts Discussed in Thread: OPA1612 , THS4541 , THS4520 , LMH5401 Hello team,
I would need some advice/help from someone with analog amplifiers / IF amplifiers expertise.
It is about improving the sensitivity of the intermediate…
Dear M. Theodorus,
Thank you for your reply.
In fact I have the habit to work with the other amplifier of the OPA3xx series which have rail to rail input. Due to this I didn't check the input limitation of the OPA211.
I correct my design by applying…
Part Number: OPA211
Hi sir:
I have two question：
1. when the temp is -40℃（I just test low temp on this），the OPA211 will self-excited about 1-2 Mhz single.
2. switch1 and switch 2,connect to 1.OPA211. then the 2 OPA211 VIn=2.5V &-2.49V. the Vout…
Part Number: OPA211 Hi Team,
The datasheet says the input voltage noise is 80nVPP (0.1 to 10 Hz), may I know which kind of instruments is used to measure such low noise? Because now we want to measure the 20uVRMS noise (0 ~100kHz), but there is no such…
Not sure why you areg oing that way, on the ;product folder there is a tools and development tab, then there is a list of models - you want the TINA reference design then with TINA open, clicking that it opened for me right away?
http://www.ti.com/product…
