Part Number: OPA928 Other Parts Discussed in Thread: OPA2197 , Tool/software: Hi team,
I'd like to use OPA928 and OPA2197 with power supply +33.5V / -2.5V and Vcm from 0V to 20V. I don't think there is any problem because the datasheet shows max…
Part Number: OPA2197 Other Parts Discussed in Thread: OPA2350 , OPA2156 Hi,
In one circuit, it was found that the slew rate of the OPA was slow and affected the measurement accuracy. So when OPA2197 with a high slew rate was used, an improvement in accuracy…
Part Number: OPA2197
Schematic Design with OPA2197IDR
Notes:
Vpilot+: +12V
Vpilot-: -12V
The OUT PILOT line is a PLC (power line communication) line. A signal in the frequency range of 2 to 30 MHz is superimposed on this line. But these signals have…
Part Number: OPA2197 Other Parts Discussed in Thread: ALM2403-Q1 Hello everyone,
I'm developing a new device and I'm going to design a regulated voltage source that can be adjusted between -5V and +5V and can provide up to 50mA of current. Can I use OPA2197…
Part Number: OPA2197 Team,
I'm posting on behalf of my customer. They would like to know the parameter values of the OPA2197IDR when tested at 15V. Can you see if there is any historic char data for any/all of the following items?
Quiescent Current…
Part Number: OPA2191 Other Parts Discussed in Thread: OPA2197 Hi Team,
Good day. I am posting this inquiry on behalf of the customer.
"Can you tell me if OPA2197 and OPA2191 are the same silicon layout/processing and if OPA2191 is just a test-out to tighter…
Part Number: OPA2191 Other Parts Discussed in Thread: OPA2197 , OPA2192 Hi Team,
Good day. I am posting this inquiry on behalf of the customer.
"Can you tell me if OPA2197 and OPA2191 are the same silicon layout/processing and if OPA2191 is just a test…
Part Number: OPA2197 Other Parts Discussed in Thread: TINA-TI Hi Team,
Our customer would like to simulate phase margin by LT Spice.
Currently, they use “ OPAx197 Pspice model(Rev.D) ”.
However, they can’t simulate phase margin.
Is it…
Part Number: OPA2197 Dear Ti Expert,
I am using OPA2197 (Vs=5V -Single supply ) for my application and calculating worst case offset voltage due to PSRR
below is the snapshot of the OPA2197 and highlighted parameter I am using for calculating offset voltage…
Part Number: OPA2197-Q1 Other Parts Discussed in Thread: OPA2197 , Dear TI Expert
In one of the reference design application ,I see OPA2197-Q1 is used as following.OPA2197 is being used for the supply for the sensor (Vin=4V) but my question what is the…
